Fellowes PS-62C User Manual
ENGLISH
FRANÇAIS
-62C
PS
Please read these instructions before use.
Veuillez lire ce Mode d’emploi avant utilisation.
Favor de leer estas instrucciones antes del uso.
ESPAÑOL
I
O
R
6
1
7
4
5
8
2
3
Dear Customer,
Thank you for buying a Fellowes Personal Shredder.
We have made many improvements in our personal
shredder since its introduction in 1990 as the first of its
kind on the market.
We are confident that it offers you the greatest value
for your money in its product category today. We hope
it meets – or even exceeds – your expectations.
To ensure years of safe, efficient use, please read these
few pages about your new shredder. If this manual
doesn’t answer all your questions or if you wish to
comment on this product, we welcome your call or letter.
Sincerely,
James Fellowes
Chairman & CEO
Contents
Product Profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Set-Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Maintenance
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Limited W
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
arranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
2
Product Profile
This product is built to shred
built to take paper clips, continuous forms, adhesive labels, transparencies, newspaper, cardboard or any plastic other than credit cards.
Using it for these purposes is likely to cause damage.
paper, staples and credit cards
. It is
not
ENGLISH
Sheet capacity* 6 sheets
Paper shred size 5/32" x 2" (3.9 x 50 mm)
Maximum paper width 9" (229 mm)
Recommended daily capacity 25-50 shredding passes
Maximum running time 10-12 minutes
Automatic cool-down period 15 minutes
Voltage 120 V/ 60 Hz/1.5A
*Based on 20 lb., 8-1/2" x 11" (75gsm) paper with shredder operating at rated voltage; heavier paper, high humidity,
or other than rated voltage may reduce sheet capacity.
Confetti-cut
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING
While setting up shredder
• Check shredder for damage or defects; some paper particles in the basket are normal
due to product testing and does not indicate a defect.
• Do not use this product if the cord has been damaged in any way.
• Avoid touching exposed blades on underside of confetti-cut shredder head.
• Remove all packing materials before using shredder.
• Plug power cord in an outlet that can easily be reached.
• Do not place shredder near or over a heat or water source.
While operating shredder
• Keep hands and hanging objects (jewelry, ties, loose clothing,
long hair, etc.) away from paper entry.
• Keep children and pets away from the shredder.
When not in use
• Always turn off and unplug shredder.
• Unplug before emptying basket.
• Do not open shredder head: Danger of electric shock.
NOTE:
Do not use flammable synthetic oil, petroleum-based products
or aerosols of any kind on or near product at any time.
3
Set-Up
This shredder will only operate when used with the supplied basket. The supplied basket has
a built-in safety feature which prevents the shredder from operating if used with any other
basket.
• Shredder comes completely assembled.
• Remove all packing materials before using shredder.
ENGLISH
• Basket must be pushed all the way in to operate.
Operation
For convenience, your shredder is equipped with an
that when the control switch (5) is in the automatic [I] position, the shredder will start running
when paper is fed into it. The shredder stops a few seconds after the paper has passed
through. Because the sensor cannot tell the difference between paper and other objects, this
feature can be a hazard, especially to children and pets. To avoid accidents, turn off the
shredder as soon as you are finished. Unplug shredder if it will not be used for an extended
period.
To shred
• Plug in shredder with control switch (5) in off [O] position
• Press control switch to automatic [I] position; cutting cylinders will run for 1-2 seconds.
• Feed paper straight into entry (1), until the shredder automatically begins shredding; see
Product Profile
• Shred for no more than 10-12 minutes; shredding longer will cause shredder to turn itself
off for 15 minutes to cool down.
• Press control switch to off [O] position after cutting has stopped.
In case of a
bilities, press the control switch to the off [O] position and empty the basket if full. Then:
1) Press and hold control switch in reverse [R] position and attempt to back paper out of
shredder.
2) If shredder jams in reverse mode, press control switch to automatic [I] position and
attempt to continue shredding operation.
3) If shredder jams again, alternate control switch slowly between reverse [R] and automatic
[I] positions to attempt to move jammed paper completely through shredder.
If you are unable to clear the jam using this method, turn off and unplug the shredder;
remove wastebasket from the cabinet and carefully remove any paper extending below the
cutting cylinders; empty wastebasket; insert wastebasket and repeat jam clearing procedure.
automatic-start sensor (7)
for limits on paper width, shreddable items, sheet capacity, etc.
paper jam
, which may occur if the shredder is pushed beyond its specified capa-
. This means
4
Maintenance
Regular emptying of the basket
cylinders. If you can see paper in the basket window (8), turn off the shredder, pull out basket
and empty basket contents.
Regular oiling of the shredder
If you are running the shredder at or near capacity, we recommend oiling it
ly
. Using Fellowes Powershred Lubricant #35250 or other non-aerosol vegetable-
based oil in a long-nozzle container:
• Apply oil over full width of paper entry (1) with shredder in off [O] position.
• Press control switch to automatic [I] position which will cause shredder to run for about 2
seconds.
• Press and hold control switch in reverse [R] position for 3–5 seconds.
• Repeat above automatic [I] and reverse [R] sequence three times.
REMINDER:
aerosol lubricants of any kind in or near the shredder at any time.
Do not use flammable synthetic oil, petroleum-based products or
is important to ensure the smooth operation of the cutting
is also necessary to ensure proper performance.
month-
Troubleshooting
If you have a problem with your shredder, check the symptoms and remedies below. If you
cannot solve the problem this way, contact Fellowes Customer Service.
shredder head
your warranty.
to attempt repair: It could expose you to serious electric shock and will void
Do not open
ENGLISH
Symptom
Shredder does not start or stops while
shredding.
Shredder squeaks, grinds or runs below
capacity.
Shredder continues to run for a few seconds
after paper has cleared the cutting cylinders.
Remedy
• Make sure shredder is plugged in and
switch is in automatic [I] position.
• If paper appears to be jammed, follow
instructions under
• Check basket position; basket must be
pushed all the way in the cabinet. Follow
instructions under
• Wait 15 minutes for shredder to cool down
before trying again.
• Oil cutting cylinders. Follow instructions
under
Maintenance
• Check window. If paper is visible, empty
basket. Follow instructions under
Maintenance
No action required. This is a self-cleaning
function.
.
Operation
Set-Up
.
.
.
5
Customer Service
Fellowes offers a
Mexico and Australia. If you live outside these regions or are otherwise unable to use our help
line, please call the Fellowes location nearest you, send a letter or email, or contact your local
dealer. All of our customer service phone numbers and other points of contact are listed on
the back of this manual.
toll-free help line
for customers living in the United States, Canada,
ENGLISH
Limited Warranty
Fellowes, Inc. warrants the cutting cylinders of the machine to be free from defects in material
and workmanship for
warrants all other parts of the machine to be free of defects in material and workmanship for
1 year
tive during the warranty period, your sole and exclusive remedy will be repair or replacement,
at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling or unauthorised repair. ANY
IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD
SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental
damages attributable to this product. This warranty gives you specific legal rights. You may
have other legal rights that vary. The duration, terms and conditions of this warranty are valid
worldwide, except where different limitations, restrictions or conditions may be required by
local law.
For more details or to obtain service under this warranty, please contact us (see back cover) or
your dealer.
5 years
from the date of purchase by the original consumer. Fellowes
from the date of purchase by the original consumer. If any part is found to be defec-
6
Loading...