Fairchild Semiconductor MM74HC151M, MM74HC151MTC, MM74HC151MTCX, MM74HC151SJ, MM74HC151MX Datasheet

...
MM74HC151 8-Channel Digital Multiplexer
MM74HC151 8-Channel Digital Multiplexer
September 1983 Revised February 1999
General Description
The MM74HC151 high speed Digital multiplexer utilizes advanced silicon-gate CMOS technology. Along with the high noise immunity and low pow er dissip ation of stan dard CMOS integrated circuits, it possesses the ability to drive 10 LS-TTL loads. The MM74HC151 selects o ne of the 8 data sources, depend ing on the address p resented o n the A, B, and C inputs. I t features both true (Y) and comple­ment (W) outputs. The STROBE input must be at a low logic level to enable this multiplexer. A high logic level at the STROBE forces the W output HIGH and the Y output LOW.
The 74HC logic family is functionally as well as pin-out compatible with the standard 74LS logic family. All inputs are protected from damage due to static discharge by inter­nal diode clamps to V
and ground.
CC
Features
Typical propagation delay data select to output Y: 26 ns
Wide operating supply voltage range: 2–6V
Low input current: 1 µA maximum
Low quiescent supply current: 80 µA maximum (74HC)
High output drive current: 4 mA minimum
Ordering Code:
Order Number Package Number Package Description
MM74HC151M M16A 16-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150” Narrow MM74HC151SJ M16D 16-Lead Small Outline Package (SOP), EIAJ TYPE II, 5.3mm Wide MM74HC151MTC MTC16 16-Lead Thin Shrink Small Outline Package (TSSOP), JEDEC MO-153, 4.4mm Wide MM74HC151N N16E 16-Lead Plastic Dual-In-Line Package (PDIP), JEDEC MS-001, 0.300” Wide
Devices also availab le in Tape and Reel. Specify by appending th e s uffix let t er “X” to the ordering code.
Connection Diagram
Pin Assignments for DIP, SOIC, SOP and TSSOP
Top View
Truth Table
Inputs Outputs
Select Strobe
CBA S Y W
XXX H L H LLL L D0D0 LLH L D1D1 LHL L D2D2 LHH L D3D3 HLL L D4D4 HLH L D5D5 HHL L D6D6 HHH L D7D7
H = HIGH Level, L = LOW Level, X = Don't Care D0, D1...D7 = the level of the respective D input
© 1999 Fairchild Semiconductor Corporation DS005313.prf www.fairchildsemi.com
Logic Diagram
MM74HC151
www.fairchildsemi.com 2
Absolute Maximum Ratings(Note 1)
(Note 2)
Supply Voltage (VCC) 0.5 to +7.0V DC Input Voltage (V DC Output Voltage (V Clamp Diode Current (I DC Output Current, per pin (I
or GND Current, per pin (ICC) ±50 mA
DC V
CC
Storage Temperature Range (T Power Dissipation (P
(Note 3) 600 mW S.O. Package only 500 mW
Lead Temperature (T
(Soldering 10 seconds )
) 1.5 to V
IN
) 0.5 to V
OUT
, IOK) ±20 mA
IK
) ±25 mA
OUT
) 65°C to +150°C
STG
)
D
)260°C
L
CC CC
Recommended Operating Conditions
+1.5V
Supply Voltage (V
+0.5V
DC Input or Output Voltage 0 V
, V
(V
IN
OUT
Operating Temperature Range (T Input Rise or Fall Times
, tf) V
(t
r
CC
V
CC
V
Note 1: Absolute Maximum Ra tings are those valu es beyond w hich dam­age to the device may occur.
Note 2: Unless otherwise specified all voltages are referenced to ground. Note 3: Power Dissipation te mperature d erating — pl astic “N” pa ckage:
12 mW/°C from 65°C to 85°C.
CC
)26V
CC
)
) 40 +85 °C
A
= 2.0V 1000 ns
= 4.5V 500 ns = 6.0V 400 ns
Min Max Units
CC
DC Electrical Characteristics (Note 4)
Symbol Parameter Conditions
V
Minimum HIGH Level 2.0V 1.5 1.5 1.5 V
IH
Input Voltage 4.5V 3.15 3.15 3.15 V
V
Maximum LOW Level 2.0V 0.5 0.5 0.5 V
IL
Input Voltage 4.5V 1.35 1.35 1.35 V
V
Minimum HIGH Level V
OH
Output Voltage |I
V
Maximum LOW Level V
OL
Output Voltage |I
I
Maximum Input V
IN
Current
I
Maximum Quiescent V
CC
Supply Current I
Note 4: For a powe r supply o f 5V ±10% the worst case output voltages (VOH, and VOL) occur for HC at 4.5V. Thus the 4. 5V valu es shou ld be u sed when designing with this supply. Worst case V
, ICC, and IOZ) occur for CMOS at the higher voltage and so th e 6. 0V values should be us ed.
rent (I
IN
= VIH or V
IN OUT
V
IN
|I
OUT
|I
OUT IN OUT
V
IN
|I
OUT
|I
OUT IN
IN
OUT
and VIL occur at V
IH
IL
| 20 µA 2.0V 2.0 1.9 1.9 1.9 V
= VIH or V
IL
| 4.0 mA 4.5V 4.2 3.98 3.84 3.7 V | 5.2 mA 6.0V 5.7 5.48 5.34 5.2 V
= VIH or V
IL
| 20 µA 2.0V 0 0.1 0.1 0.1 V
= VIH or V
IL
| 4.0 mA 4.5V 0.2 0.26 0.33 0.4 V | 5.2 mA 6.0V 0.2 0.26 0.33 0.4 V
= VCC or GND 6.0V ±0.1 ±1.0 ±1.0 µA
= VCC or GND 6.0V 8.0 80 160 µA
= 0 µA
CC
V
CC
6.0V 4.2 4.2 4.2 V
6.0V 1.8 1.8 1.8 V
4.5V 4.5 4.4 4.4 4.4 V
6.0V 6.0 5.9 5.9 5.9 V
4.5V 0 0.1 0.1 0.1 V
6.0V 0 0.1 0.1 0.1 V
= 5.5V and 4.5V respectively. (The VIH value at 5.5V is 3 .8 5V.) The worst c as e leakage cur-
TA = 25°CTA = −40 to 85°CTA = −55 to 125°C
Typ Guaranteed Limits
MM74HC151
V
Units
3 www.fairchildsemi.com
Loading...
+ 4 hidden pages