Keypad Overview
Program Key
Wireless Keypad Instructions
FOR YOUR CONVENIENCE —IT'S EASIER TO PERFORM PROGRAMMING BEFORE
MOUNTING KEYPAD.
WARNING
LED Off
A moving door can cause serious injury or death.
LED
Keypad
Up/Down Key
(enter)
Keypad Off
Keypad LED's
LED On
LED Flashing
Keypad On Keypad Flashing
DO NOT
.
WARNING
If Safety Reverse does not work properly:
DO NOT
Door and Door Opener Owner’s Manuals
yrtnE deliaF seirtnE lufsseccuS
Preparation for Use
Up/Down key
Program key
Program key
ALL
38318501760
ALL
®
HOLD
Green
Red
1
Setting Up a PIN
Program key
Program key
Programming
Locate Your Opener’s Programming Buttons and LED
New Genie Openers
Other New Model Genie Openers:
For multiple doors only
or
Program key
Program key
RADIO
SIGNAL
LEARN
CODE
or
LEARN LIMITMANUAL
Synchronizing Keypad to Opener
PROGRAM
SET
HOLD 2 seconds
+
–
Program Set key
PROGRAM
SET
–
OPEN
SET
FORCE
SET
CLOSECODE
+
LEARN
CODE
PROGRAM
SET
+
–
Green
HOLD
Program key
Red
Up/Down Key
RADIO
SIGNAL
LEARN
CODE
RADIO
SIGNAL
LEARN
CODE
Program key
NOTE: The Learn Code button and LED may be located under the light lens
or you may have to remove your unit's cover.
2
OpenerOpener
Using The Keypad
Up/Down key
Opener
Up/Down key
Up/Down key
NOTE: Pressing any key will stop or start the opener while the door is in
motion. The door will automatically stop fully open or closed. When the
door has stopped moving, pressing on any single button will activate door
until backlight goes off (30 seconds).
NOTE: Rapid blinking of the red LED on the Powerhead indicates an error.
When the blinking stops, you must start programming steps over.
For multiple doors only
For multiple doors only
Mounting Keypad
Opener
The keypad MUST be mounted within sight of the garage door(s)
at least 5 feet above the floor and clear of any moving door part.
Up/Down key
or or
Up/Down key
Up/Down key
or or
Opener
Up/Down key
Up/Down key
MUST MUST
NOTE: Pressing any key will stop or start the opener while the door is in
motion. The door will automatically stop fully open or closed. When the
door has stopped moving, pressing on any single button will activate door
until backlight goes off (30 seconds).
NOTE: Rapid blinking of the red LED on the Powerhead indicates an error.
When the blinking stops, you must start programming steps over.
Screw
head gap
1/8"
Wall
(Continued other side)
3
Mounting Keypad
DO NOT
Resetting PIN
If you have forgotten your PIN or you fear it may have fallen into
unauthorized hands, you must erase the old programming.
HOLD HOLD
Temporary PIN
Program key
Program key
NOTE: The temporary PIN is automatically cancelled whenever you
enter your normal PIN after the temporary PIN is set.
Program key Up/Down key
"Setting Up a Pin"
"Programming"
Changing Your PIN
Program key
Program key
Replacing Batteries
Additional Genie® products can be ordered through your local GENIE® Professional Dealer. To locate a dealer near you–call 800-OK-GENIE.
If the first five digits of your serial number fall between 10289 and 11188 contact Genie for assistance 800-354-3643.
FCC and IC CERTIFIED
4
Loading...