Ernesto CB 90 Instructions For Use Manual

Components of the Culinary Blowtorch CB 90

The device consists of 1 Culinary Blowtorch, 1 gas canister and 1
operating instructions

Description of the Culinary Blowtorch:

1. Burner

2. Flame adjustment lever (big flame Å / small flame È)

3. Piezo ignition button

4. Release safety latch

5. Grip with integrated gas tank

6. Continuous flame lever

7. Gas filling valve

8. Screwed on safety foot

Please check that the article is complete.

Important: To get acquainted with the device please read these
instructions for use carefully before use. Keep this leaflet for further
references.

Safety instructions and warnings

· Read instruction for use before operating the device.

· Follow safety instruction on the gas refill!

· Safety foot: The device is delivered with a safety foot (No. ), so

that the burner can be put down safely and easily.

The safety foot (No. ) is firmly screwed onto the gas tank.

· Make sure you put down the device on a horizontal surface, so that

it does not drop over.

· KEEP THE DEVICE AND THE REFILL CYLINDER ALWAYS
AWAY FORM CHILDREN.

· Do not use any device that leaks (you can smell the gas) or is damaged
or does not work properly! (risk of injury).

· Do not check for leaks with a naked flame, use soupsuds.

· Do not touch the burner if hot (risk of burns)!

· The burner is still very hot after switching off the flame. Avoid touching

the burner.

·

Caution: Accessible parts can get very hot. Keep the device
away from children.

Do not put the ignited burner down (risk of

fire). Do not leave the device unattended if it is on. Caution! Also
after use do not place the hot burner on inflammable materials (risk
of fire).

· During breaks and at the end of each usage switch off the flame

immediately (risk of burns).

· Keep the nozzle protected from dust and do not let the device fall
down. These are the most common causes of defects.

· Use the device only in properly ventilated places and in sufficient
distance from combustible sources or inflammable materials.

· Keep the device always away from the face, body or clothes, if it is
switched on and in operation.

· Store the device and the gas canister protected from direct sunlight.

Do not expose to temperatures over 50°C.

· Propane/butane is an extremely flammable gas, handle with care.

· Make sure that after each use the flame adjustment lever (No. ) is

Instructions for use

No. 48790
Culinary Blowtorch CB 90

EN

in position È, the continuous flame lever (No. ) is in position OFF
and the flame is completely extinguished.

· Let the device cool down after use before you store it.

· Do not use the device continuously for longer than 10 minutes.

Allow a cooling period of 5 minutes afterwards, refill the gas if
necessary and ignite the device again.

· Do not make any modifications to firmly assembled parts of the device.

· Never use the device near heat sources or near an open flame.

· Do not open up the device by drilling or likewise.

· Take note of all safety regulations and precautions listed on the refill

gas cylinder.

· Do not keep the device unattended when it is operated or during the
cooling down phase.

· Do not keep the device and the refill gas near heat sources (heaters,
electrical appliances, ovens or strong sun radiation, etc).

· The device is not suitable to ignite charcoal grills because of a too
strong return heat  risk of burns.

· The device does not have electrical insulation. Work only on devices
or on parts of devices which are completely without electrical power.

· Do not shake the device before and during operation. Otherwise there
is a danger that the liquid gas can get into the burner and a reddish
blazing uncontrolled flame could occur. The combustibility of the
device is then disturbed! In such a case immediately slide the
continuous flame lever (No.

) into position OFF. The gas supply

stops and no further gas can escape uncontrolled.

· IMPORTANT: After igniting the burner in a proper way, let it preheat
for a short time (appx. 30 seconds) until the burner head has reached
the optimal operation temperature.

Test for Leaks

Be very careful to test leak tightness of your device only outside. Never
seek leaking connections using a flame. Always spread soapsuds over
the connections (e.g. a half a glass of water + 10 drops of washing-up
liquid) or use a leak-seeking-spray!

If gas leaks out of your device (you can smell gas), take it immediately
outside to a place with a good air circulation and no inflammable sources,
where you can look for the leak and fix it.

Intended use

This handy gas burner is an ideal helper in your kitchen. It is ideal for
caramelizing sweets, e.g. crème brûlée. The culinary torch is also
suitable for the production of a crisp crust on roast and poultry. It is
Ideal for flambéing, for peeling off peppers and tomatoes, as well as
gratinating of cheese (onion soup, etc.).
This device is only intended for use in private households. Never use
the device for commercial purposes.

Filling the device with gas

This burner is for dispatch and safety reasons delivered without
a gas filling. Before putting into operation please fill the device at the

bottom side through the gas filling valve (No.) with provided refill gas
(also see picture A). Afterwards make sure that the gas filling valve
(No. ) is tightly closed. Take a half glass of water with 10 drops of
washing-up liquid and brush the gas filling valve with it (No. ). If there
is a leak you will see little bubbles forming.
 Use only supplied propane/butane gas mixture (e.g. the supplied

cylinder No. 70891 or refill cylinders No. 48899, No. 52103). Alternatively
you can also use refilling gas for lighters which contains only butane.
The refilling gas must by no means contain a higher propane amount
than the supplied refilling gas (see inscription on cylinder of the
provided refill gas).

 To fill the gas it is important to close first the flame adjustment lever

at the burner (No. ). In this case slide the flame adjustment lever
to position È.

 Insert the cylinder filling nozzle of the refill gas (see picture A) pointing

down vertically onto the gas filling valve (No.). For best results use
pumping actions. After filling/refilling wait a few minutes so that the
gas becomes stabilized. Ignite only after this procedure.

 Filling must be carried out outside and in a distance from all possible

igniting sources, such as open flames, pilot lights, electrical cooking
appliances and away from other persons. Do not smoke when filling
the device (Risk of explosion in case of non-observance).

Use the device only in well ventilated rooms.

IE

CY

IAN 102449

Löt- und Gasgeräte GmbH
Bahnhofstraße 50, D-74254 Offenau
Tel. [phone]
Fax [phone]
Internet: www.cfh-gmbh.de
E-Mail: [e-mail]

Stand: VO-07.14

A At first fill the device with the supplied gas for lighters as shown

on the picture. Press (pump) the cylinder several times at the
gas filling valve.

B Flame adjustment: When igniting the device position the flame

adjustment lever in the middle between min. È and max. Å.
With the flame adjustment lever you can adjust the flame length
(small/big). You can adjust the length of the flame during the
use by moving the flame adjustment lever (picture B) back and
forth. Sliding towards Å causes a stronger flame, towards È a
weaker flame.

C Release the safety latch of the piezo ignition: Simply push

down the red safety latch, which is under the piezo ignition
button, and release it.

D Ignite: Press now piezo ignition button and hold it.

Attention: The piezo ignition button (picture D) can be pressed

only if the red release safety latch (picture C), which is
underneath, has been pushed down. Note: If the piezo ignition
button (picture D) is not pressed in correctly, the safety latch
(picture C) springs up immediately and it is not possible to
press the ignition button or to ignite the device. If this happens
start the ignition process from the beginning!

E Continuous flame: Hold the piezo ignition button pressed and

at the same time slide the red continuous flame lever (as the
black lower arrow indicates in picture E) to the position LOCK
 ready. The flame of the device burns now continuously.

F Switch off the device: To extinguish the flame, simply release

the piezo ignition button. If the continuous flame lever is in
position LOCK, slide it into the OFF position (see picture F).
The device is switched off.

Storage and transportation

After end of work and before storage ensure that the device has cooled
down completely (at least 20 minutes). Afterwards you can store it in a
secure and dry place. For transport make sure that the device has cooled
down completely. Ensure that the Culinary Torch is secured during
transport.

Cleaning the device

To clean the device, wait until the burner has cooled down and use a
dry cloth. Do not use any cleansing agents because the openings in the
burner and the nozzle could become blocked.

Care of the device + maintenance

Use only recommended spare parts. Do not use a device where any
parts are damaged. Any repairs, as well as replacement of the nozzles,
must be carried out only by an authorized specialist dealer for liquid gas
or the manufacturer/distributor. In case of repair please contact the
manufacturer under the address stated below.

Do not change settings of the device or make modifications from those
set by the producer. It could be dangerous to change the structure of
the device on your own authority, to remove parts or to use parts which
are not approved by the manufacturer/distributor.

Service Address & Manufacturer:

Ignition/Adjustment of the flame Warranty

You are granted a two-year warranty for this device as of the date of
purchase. The warranty period starts on the date of purchase. Please
keep the original sales receipt for further reference. The receipt will be
required as a proof of purchase. If a material or manufacturing fault
appears within 2 years as of the date of purchase of this product, CFH
will, at its discretion, repair or replace this product free of charge. This
warranty will only be granted within two years provided the defective
device and the purchase of evidence (sales receipt) is presented as well
as a short written description stating the character of the defect and time
when it appeared. After the defect has been resolved through our
warranty, you will get the repaired or the new product back. No new
warranty period is granted with repair or replacement of the product.
In case of a warranty claim, please contact us by e-mail under info@cfh­gmbh.de. We will get in touch with you immediately.

Environmental instructions

The liquid gas used is environmentally friendly, which does not burden
or damage the environment and it is not dangerous for the ozone layer.
Follow the regulations for the liquid gas. The refill cylinder or its contents
do not have a restricted shelf-life.

Disposal of the refill cylinder

Emptied gas cylinders can be disposed of through using the waste
recycling system. Not fully emptied gas cylinders have to be disposed
of at collection centres for harmful substances.

Disposal of the device

The device is produced of recyclable materials. To dispose of or to
recycle this device, get in touch with an authorized local Recycling Office
or a waste disposal company.

We hope the Culinary Torch CB 90 will be a useful and reliable helper
in your kitchen for many years.

Technical data

Consumption: appx. 44 g/h
Nominal heat load/capacity: appx. 0,60 kW
Ignition system: piezo ignition
Gas type: mixture of propane/butane

The power rating in the instructions for use are values which had been
measured under laboratory conditions (according to DIN EN 521 5.19).
It is possible to measure other consumption data when using the device
with the propane/butane refill. (Important information: The ambient
temperature has an essential influence on the performance of the device.
As a general rule is that the performance decreases at low temperatures).

Technical and optical parameters are subject to change.

Picture

C

Release safety latch

Picture A
Filling

Picture B
Flame adjustment

Picture F
Switch off the device

Picture

D

Ignition

Picture

E

Continuous flame