Page 1
D-Link DVG - 2101sp ATA Setup Guide
With PSTN Lifeline
Light is on when
device is powered
up
Light is on when
the VoIP account
is registered
Light is on when the
phone is in use
Light is on when
Provisioning is
taking place
Light is on when
the Ethernet cable
is connected
Light is on if
PSTN Lifeline is
in use
gotalk DVG-2101sp Setup Guide
17/02/2009
Page 1 of 6
Page 2
RJ11 phone cable
to “Phone” or
“Line” port of the
Filter/splitter
RJ11 Phone
cable to the
Phone used to
make VoIP calls
Ethernet cable
to LAN port of
Modem/Router
Power cable
Continue below for VoIP configuration guide
Pick up the handset attached to the DLink ATA and dial *666#
Press 2 on the phones keypad
Press 1 to hear the DHCP IP address to enter into the web browser to get to the ATA configuration
page
gotalk DVG-2101sp Setup Guide
17/02/2009
Page 2 of 6
Page 3
Log in to the web GUI by entering into a web browser http://192.168.1.150 (example only, use the
address provided above by dialing *666# 1 2)
You will see the following page log in page
Enter the user name as “admin”
Password remains Blank
gotalk DVG-2101sp Setup Guide
17/02/2009
Page 3 of 6
Page 4
On the left hand side menu select “VoIP”
gotalk DVG-2101sp Setup Guide
17/02/2009
Page 4 of 6
Page 5
This will take you to the “VoIP Account settings page”
Ensure the settings in the device match the above image
Ensure “use domain to register” has a tick in the box
Click “Apply” and the VoIP is ready to use, the device does not need to be rest after clicking “Apply”
gotalk DVG-2101sp Setup Guide
17/02/2009
Page 5 of 6
Page 6
Changing codecs
On the top headings, select “Advanced”
Then on the left hand side menu select “VoIP” and hover the mouse until the drop down list appears,
then select “Codec” from the drop down list
As shown in the image below
Select the codec you wish to use and click “Apply” at the bottom
gotalk DVG-2101sp Setup Guide
17/02/2009
Page 6 of 6
Loading...