D-link DVG-2101S User Manual [ru]

This product can be set up using any current web browser, i.e., Internet Explorer 6 or Netscape Navigator 6.2.3.
Before You Begin
1. If you purchased this VoIP Telephone Adapter to share your high-speed Internet connection with other computers, you must have an established Internet account from an Internet Service Provider (ISP).
2. It’s best to use the same computer that is connected to your router for configuring the DVG-2101S VoIP Telephone Adapter. The DVG-2101S acts as a DHCP Client and will be assigned all the necessary IP address information from your network. See the Quick Installation Guide or the Manual on the CD-ROM for setting each network adapter to automatically obtain an IP address.
Check Your Package Contents
DVG-2101S
VoIP Telephone Adapter
D-Link DVG-2101SVoIP Telephone Adapter
CD-ROM (containing Manual and Q.I.G.)
Ethernet Cable
Phone Cable
12V, 1.5A Power Adapter
Quick Installation Guide
Using a power supply with a different voltage rating will damage and void the warranty for this product.
If any of the above items are missing, please contact your reseller.
©2007 D-Link Corporation, Inc. All rights reserved. Trademarks or registered trademarks are the property of their respective holders. Software and specifications subject to change without notice.
1
Hardware Overview
g
Front Panel
Register LED
This LED will light solid if the phone account registers successfully. This LED will flash during registering and light off if registering fails.
Power LED
This LED will light solid when the device finishes a self-test and booting up. This LED will flash during device self-test and bootin
and light off if
Phone LED
This LED will light solid when the telephone is off-hook. A fast blinking LED indicates an incoming call and a slow blinking LED indicates a message is waiting. This LED will light off if the phone connected to the phone port is on-hook.
Provision LED
This LED will light solid if the device provisions successfully. This LED will flash during provisioning and light off if provisioning fails.
WAN LED
This LED will light solid when a connection is established and blink to indicate activity. If this LED does not light up when a cable is connected, verify the cable connections and make sure your devices are powered on.
2
Rear Panel
(
Reset Button
Use a paper clip to:
1. Press 1-2 seconds to enable IVR.
2. Press 4-6 seconds to reset this unit.
3. Press 8-10 seconds to restore this unit’s factory default settings.
Phone Port
Connects to your phone using a standard phone cable
RJ-11).
Power Receptor
Connects to the provided power adapter.
WAN Port
Connects to your broadband modem using an Ethernet cable.
3
Configure IP Settings
To connect to the network, make sure the network adapter in your computer is configured properly. Here’s how to assign a static IP address to your PC.
Go to Start > click Control Panel > click on the Network
Connections
icon.
Click on the
Network Connections
icon.
Right-click the Local Area Connection icon, and then select Properties.
Select Properties.
4
The dialog box displays a list of currently installed network items.
Click Internet Protocol (TCP/IP).
Select Properties.
Make the choice to get the IP address assigned manually.
Select Use the following IP address to get the IP settings assigned manually.
Click OK.
5
Loading...
+ 9 hidden pages