D-Link DAP-2662 Quick Installation Manual
Quick Installation Guide
Nuclias Connect AC1200 Wave 2 Access Point
DAP-2662
Additional documentation is also available on the D-Link website
Contents
English 1
Before You Begin
System Requirements
This installation guide provides instructions
for installing the DAP-2662 on your network.
Additional documentation is also available on
the D-Link support website.
• Nuclias Connect Manual: For additional
information and instructions on how
to configure the device using Nuclias
Connect.
• DAP-2662 User Manual: For additional
information and instructions on how to
configure the device using the web user
interface.
Package Contents
This DAP-2662 package includes the following
items:
• DAP-2662 Access Point
• Power Adapter (Optional)
• Mounting Plate and Hardware
• Quick Start Guide
If any of the above items are damaged or
missing, please contact your local D-Link reseller.
Note: Using a power supply with a different
voltage than the one recommended for the
device will cause damage and void the warranty
for this product.
Note: No power adapter is supplied with this
product. To power the unit, use an 802.3af PoE
Switch or an 802.3af PoE Injector.
• Computers with Windows®, Macintosh®,
or Linux-based operating systems with an
installed Ethernet Adapter
• Internet Explorer 11, Safari 7, Firefox 28,
or Google Chrome 33 and above (for
configuration)
Hardware Overview
LED Indicators
1
Figure 1: Front Panel LED
# LED Description
Green (Solid) - Device operational
Power/
1
Status
Red (Flashing) - Device booting
up/Device malfunctioned
Red (Solid) - Device boot up
has failed
Table 1: LED Description
ENGLISH
DAP-2662 Quick Installation Guide
1
Interface Connectors
Using a Power Adapter (Optional)
1. Connect the power connector of the
adapter to the power input on the
DAP-2662 and plug the adapter into a
nearby power outlet.
Conguration
ENGLISH
1 3
2
Figure 2: Rear Connectors
# Connector Description
LAN(PoE)
1
2 Reset
Power
3
Installation
The DAP-2662 can be powered using one of the
following two methods:
Using Power over Ethernet (PoE)
1. Use a standard Ethernet cable to connect
the LAN port on the DAP-2662 to a PoE
power source device such as an 802.3af
PoE switch or 802.3af PoE injector.
Gigabit RJ-45 port for data and
Port
Power over Ethernet (PoE) power.
Press and hold for 10 seconds to
factory reset the device.
Input for the power adapter,
however the device can be
powered over Ethernet.
Input
Note: An 802.3af PoE injector is not
included in the package contents,
but can be purchased separately.
Table 2: Interface Description
Using Nuclias Connect
The DAP-2662 is designed to be managed
through Nuclias Connect. Refer to the Nuclias
Connect Manual for detailed configuration
instructions.
Manual Conguration
Note: D-Link recommends manually configuring
the device before mounting it. The management
computer, DHCP server and DAP-2662 must be
in the same subnet.
Use one of the following methods to access the
web user interface:
Connecting through Ethernet
1. Use an Ethernet cable to connect the
DAP-2662 to the management computer,
or to the switch or router the management
computer is connected to.
2. Manage the access point from a computer.
Enter dap2662.local in the address field
of your browser.
3. Log in to the administration user
interface. The default login information is
Username: admin
Password: admin
2
DAP-2662 Quick Installation Guide
Loading...