• Computers with Windows®, Macintosh®, or Linux-based operating systems and
ENGLISH
an installed Ethernet Adapter
• Internet Explorer version 7.0 or Firefox 3.0 or higher (for conguration)
Package Contents
D-Link DAP-2310 AirPremier® N Access Point
CAT5 Ethernet Cable
Two Detachable Antennas
Power Adapter
CD-ROM with Installation Guide, User Manual, and Special Oers
Note: Using a power supply with a dierent voltage than the one included with the
DAP-2310 may damage the unit and will void the warranty for this product.
If any of the above items are missing, please contact your reseller.
22
Hardware Overview
LEDs
2
1
3
ENGLISH
1Power LEDThis light will be solid green when the unit is powered on.
2WLAN LED
3LAN LED
This light will be flickering green when the 2.4GHz
frequency is in use.
This light will be ickering green when there is active
LAN trac.
33
Connections
ENGLISH
2
1
1LAN PortConnects the DAP-2310 to a switch or PC.
2ResetReset the Access Point.
3Power Receptor Receptor for Power Adapter.
3
Getting Started
1. You will need broadband Internet access.
2. Consult with your cable or DSL provider for proper installation of the modem.
3. Connect the Cable or DSL modem to a router.
4. If you are connecting a desktop computer to your network, install a wireless
adapter into an available slot on your desktop computer.
5. Install the drivers for your wireless adapter into a laptop computer.
44
LAN
RESET
5V
2A
1
2
Connecting the
DAP-2310 to your network
1. Connect the power adapter to the receptor on the rear panel of the
DAP-2310 and then plug the other end of the power adapter to a wall outlet
or power strip. The power LED will turn ON to indicate proper operation.
2. Using an Ethernet cable, insert one end of the cable to the LAN port on the rear
panel of the DAP-2310 and the other end of the cable to a switch or router’s
LAN port .
Note: You can also connect the DAP-2310 directly to the computer that will
be used for conguration. The LAN LED will illuminate to indicate a proper
Ethernet connection.
3. Computers with 802.11 b/g/n wireless adapters can connect to the DAP-2310.
Desktop
Monitor
ENGLISH
DAP-2310
PoE Switch
55
Connecting PoE (Power over Ethernet)
LAN
RESET
5V
2A
1
2
LAN
RESET
5V
2A
or
Connect one end of an Ethernet cable (included with your package to
ENGLISH
the LAN Port on the DAP-2310 and the other end of the Ethernet cable
to your computer or to your PoE Switch. The AP can be powered on by a
PoE switch or by the power adapter shipped with the AP.
DAP-2310
Laptop
Switch
66
Using the Conguration Menu
To congure the DAP-2310, use a computer that is connected to the DAP-2310 with
an Ethernet cable (see the
Type the IP address of the DAP-2310 in the address eld (http://192.168.0.50) and
press Enter. Make sure that the IP addresses of the DAP-2310 and your computer
are in the same subnet.
Note: If you have changed the default IP address assigned to the DAP-2310, make sure to enter
the correct IP address.
.
Enter the user name (admin) and your password. Leave the password eld blank by default
and click Login.
Note: If you have changed the password, make sure to enter the correct password.
Network Layout diagram
).Launch your web browser.
ENGLISH
77
Technical Support
D-Link’s website contains the latest user documentation and software
updates for D-Link products.
U.S. and Canadian customers can contact D-Link Technical Support