Dear Sir/Madam
We thank you for purchasing this Pinguino
appliance and congratulate you on your wise
choice.
Please make the time and effort to read this
manual carefully.
Becoming familiar with the Pinguino is an
essential step if you are to benefit fully from its
exceptional qualities, during both installation
and actual use.
We hope that the Pinguino will become a
welcome friend this summer, a source of comfort
and refreshment.
Best wishes
De Longhi S.p.A.
18
GENERAL DESCRIPTION
The air-conditioner is an extremely versatile air-conditioner, performing its air cooling function through
either water condensation or air condensation.
The user can choose between the two functions:
1) WATER FUNCTION - For economical, highly efficient and rapid air cooling. This function is
recommended when the appliance is first switched on and the environment is particularly hot.
2) AIR FUNCTION - For less intense cooling. A more convenient function (no need to fill water container).
The versatility of this appliance is demonstrated by its ability to switch automatically to air function
whenever the water container is empty.
TECHNICAL DATA Tab.1
WATER FUNCTION - AIR FUNCTION
Power supply voltage (V) 220...240 V ~
Frequency (Hz) 50
Electric power consumption (A) see rating label
Max.power consumption (air-condit.mode) (W) see rating label
* Cooling capacity (Frig/h, W, Btu/h) see rating label
Cooling capacity (Frig/h, W, Btu/h) see rating label
Air flow capacity (m3/h) 360
Timer 24 h
Dimensions: width (mm) 560
height 735
depth 390
Net weight (kg) 44
Technical data subject to change without prior notice
* According to standard ASHRAE 128P
Note: When indoor temperature exceeds 32°C, the appliance should be operated with water.
IDEAL OPERATING CONDITIONS Tab.2
ROOM TEMPERATURE 21 ÷ 32°C
ROOM HUMIDITY FACTOR BELOW 80%
FREQUENCY 50 Hz
POWER SUPPLY
VOLTAGE 220 ... 240 V ~
19
DESCRIPTION OF MAIN FEATURES
Air outlet grid
Programmer (timer)
Timer cover (to adjust the timer,
slide cover sideways)
Water container
Castors
Castor stops
Water collecting tray
Water container compartment
door
20
Air filter
Air intake grid
Warranty envelope
Exhaust hose compartment
Power cable compartment
Manually resettable red button
Handle
Water collecting tray
drainage tube
DESCRIPTION OF ACCESSORIES Tab. 3
DESCRIPTION
Exhaust hose
Stopper + flange
Castor stop
De-scaling fluid
Window nozzle
PARTS
SUPPLIED
1
1
2
1
1
Suction cup set
ACCESSORY CHECK
Check that all parts listed in Table 3 are included.
1
21
INSTALLATION FOR AIR-CONDITIONING FUNCTION
Our air-conditioner is portable and versatile: it
can be used as a permanent installation or wise
easily moved from one room to another.
The appliance must be fitted at least 30 cm.
from the surrounding walls.
30 cm
30 cm
When installed permanently, all air discharged from the rear hose is extracted from the room in which the
appliance is installed.
Check that the room (particularly if it is small) is not “air-tight”; a drop in pressure could cause a malfunction
and thereby activate the safety switch. Air entering the room through door and window cracks is normally
sufficient. If necessary, leave a door slightly ajar (a gap of approx.1 cm. is adequate).
The unit can also be used as a “temporary”
installation for use in any room with a window or
french window; this “temporary” installation can
be used at any time until it is ready for permanent
installation.
Note.: In either case, check that the unit is resting
on at “perfectly level” surface. If necessary, use
the 2 castor stops for the front castors.
30 cm
Permanent installation
The outlet holes must be connected to the outside of the building and cannot be made in any wall or panel.
A1
in a window pane
A2 through the wooden
base-section of a glass door
A3
in the wall
22
Ø 98 mm (3" 3/4)