DBX Series 2 Owner's Manual [fr]

Mode d’emploi

Égaliseurs graphiques
Série 2

131
215
231

2

W

ARNING FOR YOUR PROTECTION
PLEASE READ THE FOLLOWING:

KEEP THESE INSTRUCTIONS

HEED ALL WARNINGS

FOLLOW ALL INSTRUCTIONS

DO NOT USE THIS APP

ARATUS NEAR WATER

CLEAN ONLY WITH A DRY CLOTH.

DO NOT BLOCK ANY OF THE VENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH
THE MANUFACTURER’S INSTRUCTIONS.

DO NOT INST

ALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS,

STOVES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.

ONLY USE A

TTACHMENTS/ACCESSORIES SPECIFIED BY THE MANUFACTURER.

UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG
PERIODS OF TIME.

Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide blade or third prong are
provided for your safety. If the provided plug does not fit your outlet, consult an
electrician for replacement of the obsolete outlet.

Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.

Use only with the cart stand, tripod bracket, or table specified by the manufacture,
or sold with the apparatus. When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.

Refer all servicing to to qualified service personnel. Servicing is required when
the apparatus has been damaged in any way

, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.

POWER ON/OFF SWITCH: The Power switch used in this piece of equipment DOES NOT
break the connection from the mains.

MAINS DISCONNECT: The plug shall remain readily operable. For rack-mount or
installation where plug is not accessible, an all-pole mains switch with a contact
separation of at least 3 mm in each pole shall be incorporated into the electrical
installation of the rack or building.

FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE: Replace fuse
with same type and rating only.

MULTIPLE-INPUT VOLTAGE: This equipment may require the use of a different line
cord, attachment plug, or both, depending on the available power source at
installation. Connect this equipment only to the power source indicated on the
equipment rear panel. To reduce the risk of fire or electric shock, refer servicing
to qualified service personnel or equivalent.

This Equipment is intended for rack mount use only.

SAFETY INSTR

UCTIONS

NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED
WITH A POWER CORD.

WARNING: THIS APPLIANCE MUSTBE EARTHED.

The cores in the mains lead are coloured in accordance with
the following code:

GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live

As colours of the cores in the mains lead of this appliance may
not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:

• The core which is coloured green and yellow must be
connected to the terminal in the plug marked with the
letter E, or with the earth symbol, or coloured green, or
green and yellow.

• The core which is coloured blue must be connected to
the terminal marked N or coloured black.

• The core which is coloured brown must be connected to
the terminal marked L or coloured red.

This equipment may require the use of a different line cord,
attachment plug, or both, depending on the available power
source at installation. If the attachment plug needs to be
changed, refer servicing to qualified service personnel who
should refer to the table below. The green/yellow wire shall be
connected directly to the units chassis.

WARNING:If the ground is defeated, certain fault conditions in
the unit or in the system to which it is connected can result in
full line voltage between chassis and earth ground. Severe injury
or death can then result if the chassis and earth ground are
touched simultaneously.

The symbols shown above are internationally accepted
symbols that warn of potential hazards with electrical
products. The lightning flash with arrowpoint in an
equilateral triangle means that there are dangerous
voltages present within the unit. The exclamation point in
an equilateral triangle indicates that it is necessary for the
user to refer to the owner’s manual.

These symbols warn that there are no user serviceable
parts inside the unit. Do not open the unit. Do not
attempt to service the unit yourself. Refer all servicing to
qualified personnel. Opening the chassis for any reason
will void the manufacturer’s warranty. Do not get the unit
wet. If liquid is spilled on the unit, shut it off immediately
and take it to a dealer for service. Disconnect the unit
during storms to prevent damage.

IMPORTANT SAFETY INSTRUCTIONS

3

U.K. MAINS

PLUG WARNING

A molded mains plug that has been cut off from the cord is unsafe.
Discard the mains plug at a suitable disposal facility. NEVER UNDER

ANY CIRCUMSTANCES SHOULD YOU INSERT A DAMAGED OR CUT
MAINS PLUG INTO A 13 AMP POWER SOCKET. Do not use the

mains plug without the fuse cover in place. Replacement fuse covers
can be obtained from your local retailer. Replacement fuses are 13
amps and MUST be ASTA approved

to BS1362.

LITHIUM BATTERY

WARNING

CAUTION!

This product may contain a lithium battery.There is
danger of explosion if the battery is incorrectly replaced.
Replace only with an Eveready CR 2032 or equivalent.
Make sure the battery is installed with the correct
polarity. Discard used batteries according to
manufacturer’s instructions.

ADVARSEL!

Lithiumbatteri - Eksplosjonsfare.Ved utskifting benyttes
kun batteri som anbefalt av apparatfabrikanten. Brukt
batteri returneres apparatleverandøren.

ADVARSEL!

Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering.
Udskiftning må kun ske med batteri av samme fabrikat og
type. Levér det brugte batteri tilbage til leverandøren.

VAR OITUS!

Paristo voi räjähtää, jos se on virheellisesti asennettu.
Vaihda paristo ainoastaan laitevalmistajan suosittelemaan
tyyppin. Hävitä käytetty paristo valmistajan ohjeiden
mukaisesti.

VARNING!

Explosionsfara vid felaktigt batteribyte.Använd samma
batterityp eller en ekvivalent typ som rekommenderas av
apparattillverkaren. Kassera använt batteri enligt
fabrikantens instruktion.

IMPORTANT SAFETY INSTRUCTIONS

ELECTROMAGNETIC

COMP

ATIBILITY

This unit conforms to the Product
Specifications noted on the Declaration
of Conformity. Operation is subject to

the following two conditions:

• this device may not cause harmful

interference, and

• this device must accept any

interference received, including

interference that may cause

undesired operation.

Operation of this unit within significant

electromagnetic fields should be avoided.

• use only shielded interconnecting

cables.

DECLARATION OF

CONFORMITY

Manufacturer’s Name: dbx Professional Products
Manufacturer’s Address: 8760 S. Sandy Parkway

Sandy, Utah 84070, USA

declares that the product:

Product name: dbx 131, 215 and 231
Note: Product name may be suffixed

by the EU.

Product option: None

conforms to the following Product Specifications:

Safety: IEC 60065 (1998)

EMC: EN 55013 (1990)

EN 55020 (1991)

Supplementary Information:

The product herewith complies with the requirements
of the Low Voltage Directive 72/23/EEC and the EMC
Directive 89/336/EEC as amended by Directive
93/68/EEC.

Vice-President of Engineering

8760 S. Sandy Parkway

Sandy, Utah 84070, USA
Date:April 19,2002

European Contact: Your local dbx Sales and
Service Office or

Harman Music Group
8760 South Sandy Parkway
Sandy, Utah 84070 USA
Ph: [phone]
Fax: [phone]

4

Mode d’emploi

Série 2

Ta b le des matières

Consignes de sécurité ............................................3

Informations sur le SAV .........................................4

Garantie...................................................................5

Introduction et caractéristiques .............................6

Commandes ............................................................7

Connexion de l’égaliseur à votre système............8

faces arrière - Descriptions ....................................8

Consignes d’installation..........................................9

Conseils d’utilisation et d’application....................9

Caractéristiques techniques..................................10

Informations sur le SAV

If you require technical support, contact dbx Customer Service. Be prepared to
accurately describe the problem. Know the serial number of your unit - this is
printed on a sticker attached to the top panel. If you have not already taken the
time to fill out your warranty registration card and send it in, please do so now.

Before you return a product to the factory for service, we recommend you refer to
the manual. Make sure you have correctly followed installation steps and
operation procedures. If you are still unable to solve a problem, contact our
Customer Service Department at [phone] for consultation. If you need to
return a product to the factory for service, you MUST contact Customer Service to
obtain a Return Authorization Number.

No returned products will be accepted at the factory without a Return
Authorization Number.

Please refer to the Warranty information on the following page, which extends to
the first end-user. After expiration of the warranty, a reasonable charge will be
made for parts, labor, and packing if you choose to use the factory service facility.
In all cases, you are responsible for transportation charges to the factory. dbx will
pay return shipping if the unit is still under warranty.

Use the original packing material if it is available. Mark the package with the
name of the shipper and with these words in red: DELICATE INSTRUMENT,
FRAGILE! Insure the package properly. Ship prepaid, not collect. Do not ship
parcel post.