CompuSTAR CM1000S R200 User Manual

CM1000S – R200 USER’S GUIDE

___________________________________________________________________________________________________________________

T

HANK YOU

Thank you for purchasing a CompuStar alarm and/or remote start system. CompuStar alarms and remote-start systems are the most advanced
systems on the market with amazing features, incomparable ease of use, and breakthrough technologies never before utilized in the automotive
environment. Please take time to read and understand this owner’s manual so that you can enjoy your new CompuStar system.

___________________________________________________________________________________________________________________

B

UTTON FUNCTIONS

This system is a remote start only system for adding to vehicles with a factory keyless entry or factory remote build on your keys.
It may be possible to upgrade to a fully functional CompuStar remote start system. Please check with your installer for more
details.

Button 1.5 sec Notes

Remote starts vehicle

Shuts vehicle off

Parking lights on

Auxiliary (Optional)

Turns parking lights on for 30 seconds or until
button is tapped again

When tapped this button will activate a pulse
on the auxiliary

Key Button (1.5 Sec. ) – Holding the Key Butt o n fo r 1.5 seconds activates the remote start feature on your
system. The vehicle will flash the parking lights once. Once the vehicle is remote started the parking lights
will come on solid.

Stop Button (1.5 Sec.) – Holding the Stop Button for 1.5 seconds deactivates the remote start feature on
your system. Once the vehicle is shut off the parking lights will go from solid to off. The parking lights will
then flash twice to show the remote start has disengaged.

Parking Light Button (1.5 Sec.) – Holding the Parking Light button for 1.5 seconds will turn the parking
lights on solid for your vehicle. The parking lights will stay on for 30 seconds or until you hold the button
for 1.5 seconds.

Aux Button (1.5 Sec.) – Holding this button for 1.5 seconds will activate an auxiliary trigger on your
vehicle. This is an optional function and could be used to unlock your trunk or open sliding doors.

___________________________________________________________________________________________________________________

V

ALET MODE

Valet Mode bypasses the functions of your remote starter. It is used in the event you bring your vehicle in for service, loan your vehicle to
someone, or if you have your vehicle parked by valet service. Valet Mode is used as a precaution so there is no accidental activation of the
remote start.

To place your system into Valet Mode you must turn the Ignition On and Off for 5 times within 7 seconds with key. When the parking lights
flash once, pauses and then flashes twice, your system is now in Valet Mode. Please follow this diagram below:

___________________________________________________________________________________________________________________

D

IAGNOSTIC MESSAGES

1. Whenever the system fails to remote start, the vehicle provides you with diagnostic error messages: # of times parking lights flash. The
vehicle will first flash the parking lights 3 times followed by the remote start error.

2. Depending on the vehicle, it may be possible that the factory remote may not operate while the vehicle is remote started. It is not an
error the CompuStar. It is a function of the vehicle disabling factory features while the car is running.

___________________________________________________________________________________________________________________

M

ANUAL TRANSMISSION VEHICLES

To use the remote-start function on a manual transmission vehicle, you must first set Reservation Mode. Reservation mode sets the vehicle up
to safely start the next time you use the remote-start. To set Reservation Mode, follow these steps:

1. Completely stop the vehicle and put it in NEUTRAL.

2. Set the emergency brake and remove your foot from the foot brake.

3. A few seconds later you should hear a “click”.

4. Turn the key off and remove it from the ignition. The vehicle will stay running.

5. Exit the vehicle and close the door.

6. The vehicle will shut off, the system will arm, and the doors will lock.

Reservation Mode has now been set. The following actions will cancel Reservation Mode; opening the hood, doors, or trunk, turning on the
ignition, releasing the emergency brake, turning on the ignition, or triggering the alarm. If reservation mode is cancelled, you will need to get in
the vehicle and repeat the setup process.

Number of Parking

Light Flashes

1 Motor running
2 Key in ignition on position
3 Door open (manual transmission only)
4 Trunk open
5 Foot brake on
6 Hood open
7 Reservation off (manual transmission only)

8

Remote Start Error

No tach signal or voltage sensing failure
(please see your CompuStar installer)