Canon GP405, GP605, GP160, Gp-335, Gp-605v Service Bulletin acc-148
...
Service Bulletin
Issued by Canon Europa N.V.
COPIER
Model :
Location :
Subject :
Reason :
Details :
Finisher D1
SORTING GUIDE ASSEMBLY
PREVENTING STATIONARY JAMS (AROUND SORTING GUIDE)
Paper can hit the ribs in the sorting guide assembly to jam, and the problem can be corrected by
providing the measures shown herein during servi cing work.
<Symptom>
Depending on the type (degree of body) and how it is moved, paper can hit the ribs in the sorting
guide assembly to jam (stationary) in front of the sorting guide.
<Cause>
The absence of a gap between the ribs in the sorting guide assembly and passing paper hinders the
paper from moving properly, resulting in a stationary jam in front of the sorting guide.
No.:
DATE:
Acc-148 Rev. 1
(FF-T01-W-000051-02)
10.08.99
Servicing :
<Factory measure>
A spacer is attached to the ribs in the sorting guide to create a clearance between the ribs and passing
paper, thereby ensuring smooth passage of paper.
< Making Checks and Providing Measures >
1. If the delivery outlet tray is in the way,
change its location.
Fig. 1
-
1 / 3 -
Acc-148 Rev. 1
2. While holding up the swing guide, check
the gap between the sorting guide assembly
and the ribs. If the g ap is not as indicated,
perform the following steps:
3. Remove the four screws, and detach the stacking
wall (upper) of the Finisher -D1.
Clearance: 0.5 mm or more
Fig. 2
Screws
4. Remove the processing tray unit. (See pp. 3-13 through
-14 in the Service Manual; FY8-13FF-000.)
1) Remove the screw, and detach the sorting tray stopper.
2) Move up the sorting tray to its upper limit by hand. (Se e
the descriptions on the ascent of the sorting tray.)
3) Remove the four screws, and detach the stacking wall
(lower).
4) Remove the screw, and detach the connector cover.
(See Figure 4.)
5) Remove the seven connectors, and free the harness
from the cord clamp.
Fig. 3
Connector
cover
Screw
Fig. 4
Harness
Fig. 5
Connector
-
2 / 3 -
Loading...