Brother HL-600 User Manual

Brother Laser Printer HL-600 Series Quick Setup Guide

Read this guidebook first to set up your printer.

Action 1: Getting Started

Check the Supplied Items

After taking the printer out of the carton and removing the packing materials, make sure that the following items are not damaged and none are missing:

• Printer • Multi-purpose sheet feeder

• Drum unit • Toner cartridge

• 3.5” floppy disks for DOS/Windows

• Software setup guide

• Quick setup guide (this guidebook)

• User’s guide

• Plastic Bag

NOTE

The 3.5” floppy disks for the Macintosh printer driver is included in some countries. You will need to purchase an interface cable that matches the interface of your computer. If you do not know what cable you need, consult your dealer.

UL5455001 C Printed in Japan

Action 2: Install the Toner Cartridge / Drum Unit

Unpack the drum unit and gently rock it from side to side five or six times.

Remove the protective parts, in order, as shown in the illustration.

NOTE

Do not expose the drum unit to light for longer than a few minutes, as this will damage the drum.

Open the top cover. Open the drum cover by pushing the two blue tabs in toward the center of the unit and lifting the cover toward you.

Install the drum unit into the printer. Make sure that you gasp the ▲ marks.

Unpack the toner cartridge and gently rock it from side to side five or six times before installing. ( ① )

Then, remove the protective parts.( ② )

CAUTION

DO NOT MOVE THE SHUTTER LEVER UNTIL THE CARTRIDGE IS INSTALLED.

Install the toner cartridge into the drum unit. Make sure that the ▲ marks are aligned.

Gently pull the blue shutter lever on the toner cartridge forward until the red arrows are aligned.

Close the drum cover ( ① ) and push gently until it clicks into place.

Close the top cover. ( ② )

See “CHAPTER 5 MAINTENANCE” in the User’s Guide for more information about replacement of the toner cartridge.

+ 5 hidden pages