Bosch PDT 1 Working Instructions

PTD 1 – Working procedure

Please note that that there might be some deviations to the final HMI-concept
(final Software-Configuration)

Please note also that there is a bug in the current software: if you have reached an ambient
temperature of 28 °C on the display there will be following indication: “Lo” (this is a software mistake!)

1. Switching On an Off

There are following possibilities to switch on the tool:

- Switch on the tool by pressing the On/Off-button (13)

- Switch on the tool by pressing the Measuring-button (4)

- Switch off the tool by pressing the On/Off-button (13)

If no button will be pressed for four minutes, the tool will automatically switch off to save
battery capacity.

A: Surface Temperature Mode
B: Thermal Bridge Mode
C: Mould Warning Mode

2. Measurement preparation

Setup emissivity before doing a measurement (c.f. Icon Nr. 14)

Group I: (Emissivity = 0,93): Materials such as concrete (dry), brick,

sandstone, mortar, marble, stucco,

Group II (Emissivity = 0,85): granite, cobblestone, fibreboard, wallpaper,
varnish