Page 1
2. Removing the fuse holder.1. Removing the fuse drawer.
4. Reinserting the fuse drawer.3. Replacing the fuse holder with the correct
voltage visible.
2. Place the carousel on the pivot-shaft,
pushing it back over the gear drive.
1. Rotate the drop arm to the waste (rear)
position.
4. Load the carousel with 13 x 100 mm test
tubes or using the optional adaptor, 1.5 ml
microtubes.
3. Holding the gear teeth free from engagement, turn the carousel counterclockwise until it stops against the gear.
BBiioo-RRaadd MMooddeell 22111100 FFrraaccttiioonn CCoolllleeccttoorr QQuuiicckk RReeffeerreennccee GGuuiiddee**
CChhaannggiinngg tthhee FFuussee
SSttaarrtt-uupp PPrroocceedduurree
Page 2
6. Rotate the drop arm into the collect
position.
5. Install the inlet tubing using the drop fomer and arm cap.
8. Set the collection interval.7. Set the collection mode (Time or Drop).
9. Push RUN to start.
*For more detailed instructions and descriptions, refer to the instruction manual.
Bio-Rad Laboratories, 2000 Alfred Nobel Drive, Hercules, CA 94547 • Phone (510) 741-1000
9204170 REV B
Loading...