Behringer PB600 User Manual

Stompbox Accessories

PEDAL BOARD
PB600

Pedal Board with 9 V DC Power Supply
and Patch Cables

Ultra-compact and lightweight pedal
board for transporting up to 6 e ects
pedals, including patch cables

Generous 1.7 A power adapter
included for powering more
than 12 devices*—includes
1 x 6 daisy-chain cabling

Ultra-rigid plastic design withstands
even heavy impact

High-quality components and
exceptionally rugged construction
ensure long life

Conceived and designed by
BEHRINGER Germany

* Depends on the power consumption
of the e ects pedals, etc.

When e ects are an integral part of your
rig, their power adapters and patch cables
can often be the most vulnerable part, and
the most likely to sabotage your set if they're
not pampered. Rather than tossing your
pedals, power adapters and all other cabling
into a du el bag after a gig, keep them
safe—and ready to rock at a moment’s
notice—with the PB600.

It's all about connections

This awesome pedal board makes
hooking up six 2.5" x 4.5" pedals as easy
as hooking up just one (of course, if you're
using pedals that aren’t 2.5" x 4.5", the snug
foam padding can be cut to accommodate
pedals of varying shapes). The PB600
includes ¼" patch cables, so you can leave
your pedals connected to one another, ready
to pass signal even when you’re transporting
them. It also comes with 1 x 6 daisy chain
cabling so that when you plug in the 1.7 A
power adapter, all your pedals receive power.
Meanwhile, all cabling remains safe and
free of strain. Failure is almost guaranteed
when you’re dealing with a rat’s nest of loose
cabling, but with the PB600, your e ects
chain is always safe and organized.

Connect your guitar, bass or keyboard to
the single ¼" input in the upper right corner
of the board. A pair of ¼" FROM EFFECTS
jacks in the upper left corner allow you to
connect stereo e ects, and two ¼" OUTPUT
TO AMP jacks send a left and right stereo
signal to up to two amps.

When it’s time to load out, just unplug
the power supply, disconnect your guitar
and amp, put the lid back on the PB600
and slide the locking latches back into
place. The heavy-impact plastic casing will
protect your pedals from the very worst
dings, scrapes and scratches the road
throws your way.

PEDAL BOARD
PB600

ACX900

Page 2 of 3

Hookup Diagram

VT100FX

VT100FXH

412H-BK

VT30FX

VD400

UM300

EQ700DR600 BO300 CS400

AM100

CS400

HB01

HB01

BUGERA 333XL

412H-BK

PH9 TO800 EQ700