Federal Communications Commission Statement
This device complies with FCC Rules Part 15. Operation is subject to the
following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
manufacturer’s instructions, may cause harmful interference to radio
communications. However , there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver .
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The use of shielded cables for connection of the monitor to the
graphics card is required to assure compliance with FCC regulations.
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate this equipment.
Canadian Department of Communications Statement
This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus set out in the Radio Interference
Regulations of the Canadian Department of Communications.
This class B digital apparatus complies with Canadian ICES-003.
vi
PS/2KBMS
T: Mouse
B: Keyboard
SPDIF_O
COM1
USB2.0
T: USB1
B: USB2
USB2.0
Top:
T: USB3
RJ-45
B: USB4
Top:Line In
Center:Line Out
Below:Mic In
PARALLEL PORT
USBPW12
USBPW34
ATX12V1
Socket 478
SiS
655
FX
PWR_FAN1
CPU_FAN1
ATX Power Connector
PRI_IDE1
SEC_IDE1
DDR DIMM_A2 (64 bit,184-pin module)
DDR DIMM_A1 (64 bit,184-pin module)
DDR DIMM_B2 (64 bit,184-pin module)
DDR DIMM_B1 (64 bit,184-pin module)
30.5cm (12.0in)
CD1
AUX1
Audio
Codec
SPDIF_OUT
FP_AUDIO
Accelerated Graphics Port (AGP1)
PCI1
PCI2
USBPW56
USBPW78
PCI3
P4S800D
PCI4
PCI5
SB_PWR1
WIFI
USB56
USB78
COM2
GAME1
SiS
964
SATA2
SATA1
CLRTC1
Super
CHASSIS1
CHA_FAN1
CR2032 3V
Lithium Cell
CMOS Power
I/O
4Mbit
Firmware
PANEL1
FLOPPY1
Hub
1-6
DIMM_A
DIMM_A2DIMM_B
DIMM_B
P4S800D
P4S800D 184-Pin DDR DIMM Sockets
80 Pins 104 Pins
1-10
DIMM_A1 DIMM_A2 DIMM_B1 DIMM_B2
( )()()()
(1) - - (2) (3) - -
- -
(4) - - (1) - -
(2) - -
(3)
SS/DS A* B* C*
512MB Kingston KVR333X72RC25/512 Micron DS MT46V64M4TG-6TC • • •
256MB TwinMos M2G9I08AFATT9F081AA4T TwinMos SS TMD7608F8E50D • • •
512MB TwinMos M2G9J16AGATT9F081AA4T TwinMos DS TMD7608F8E50D • • •
256MB TwinMos M2S9I08AFAPS9F0811A-T PSC SS A2S56D30ATP • • •
256MB Transcend TS32MLD64V4F3 SAMSUNG SS K4H560838D-TCCC • • •
256MB A DATA MDOAD5F3G315B1EC2 A DATA SS ADD8608A8A-5B • • •
256MB A DATA MDOSS6F3G31YK1EZZ SAMSUNG SS K4H560838E-TCCC • • •
256MB GEIL MAG32UL6464D2TG5A-KC GEIL SS GL3LC32G88TG-5A • • •
512MB GEIL MAG16UL3264D1TG5A-KC GEIL DS GL3LC32G88TG-5A • • •
256MB KINGSTON KVR400X64C3A/256 Hynix SS HYB25D256800BT-5B • • •
512MB KINGSTON KVR400X64C3A/512 Hynix DS HYB25D256800BT-5B • • •
256MB Hynix HYMD232646B8J-D43AA Hynix SS HY5DU56822BT-D43 • • •
512MB Hynix HYMD264646B8J-D43AA Hynix DS HY5DU56822BT-D43 • • •
256MB CENTURY DXV6S8SSCCD3K27C SAMSUNG SS K4H560838D-TCCC • • •
1-11
IRQ
01
12
2 N/A
3* 11 (COM2)
4* 12 (COM1)
5* 13
614
7* 15 (LPT1)
83 CMOS/
9* 4 ACPI
10* 5 PCI IRQ
11* 6 PCI IRQ
12* 7 PS/2
13 8
14* 9 1 IDE
15* 10 2 IDE
(LPT2 )
PCI 1
PCI 2
PCI 3
PCI 4
PCI 5
WiFi
USB1.1/2.0 ——— —
LAN
RAID
1394
ABCDEFGH
———————
— ——————
—— —————
——— ————
———————
———————
———————
——— ————
—— —————
— ——————
—— —————
1-13
P4S800D
Keyed for 1.5v
P4S800D Accelerated Graphics Port (AGP)
1-14
USBPW34
21
2
P4S800D
P4S800D USB Device Wake Up
+5V
(Default)
USBPW56
USBPW78
21
+5V
(Default)
+5VS
2
+5VS
1-16