ANALOG DEVICES OP183 Service Manual
www.BDTIC.com/ADI
5 MHz Single-Supply
FEATURES
Single supply: 3 V to 36 V
Wide bandwidth: 5 MHz
Low offset voltage: 1 mV
High slew rate: 10 V/μs
Low noise: 10 nV/√Hz
Unity gain stable
Input and output range includes GND
No phase reversal
APPLICATIONS
Multimedia
Telecom
ADC buffers
Wide band filters
Microphone preamplifiers
GENERAL DESCRIPTION
Operational Amplifier
OP183
PIN CONNECTION
1
NULL
–IN
+IN
Figure 1. 8-Lead Narrow Body SOIC
V–
OP183
2
3
TOP VIEW
(Not to Scale)
4
(S Suffix)
8
NC
7
V+
6
OUT
5
NULL
00292-001
The OP183 is a single-supply, 5 MHz bandwidth amplifier with
slew rates of 10 V/μs. It can operate from voltages as low as 3 V
and up to 36 V. This combination of slew rate and bandwidth
yields excellent single-supply ac performance, making this
amplifier ideally suited for telecom and multimedia audio
applications.
The OP183 also provides good dc performance with guaranteed
1 mV o
ffset. Noise is a respectable 10 nV/√Hz. Supply current is
only 1.2 mA per amplifier.
This amplifier is well suited for single-supply applications that
equire moderate bandwidth even when used in high gain
r
configurations. This makes it useful in filters and instrumentation. The output drive capability and very wide full-power
bandwidth of the OP183 make it a good choice for multimedia
headphone drivers or microphone input amplifiers.
The OP183 is available in a SO-8 surface-mount package. It is
sp
ecified over the extended industrial (−40°C to +85°C)
temperature range.
Rev. D
Information furnished by Analog Devices is believed to be accurate and reliable.
However, no responsibility is assumed by Analog Devices for its use, nor for any
infringements of patents or other rights of third parties that may result from its use.
Specifications subject to change without notice. No license is granted by implication
or otherwise under any patent or patent rights of Analog Devices. Trademarks and
registered trademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700 www.analog.com
Fax: 781.461.3113 ©2005 Analog Devices, Inc. All rights reserved.
OP183
www.BDTIC.com/ADI
TABLE OF CONTENTS
Specifications..................................................................................... 3
Direct Access Arrangement...................................................... 13
Electrical Characteristics @ V
Electrical Characteristics @ V
Electrical Characteristics @ V
Absolute Maximum Ratings............................................................ 6
ESD Caution.................................................................................. 6
Typical Performance Characteristics .............................................7
Applications..................................................................................... 13
Offset Adjust ...............................................................................13
Phase Reversal............................................................................. 13
= 5 V......................................... 3
S
= 3 V......................................... 4
S
= ±15 V.................................... 5
S
REVISION HISTORY
5/05—Rev. C to Rev. D
Updated Format.................................................................. Universal
Removed OP283 .................................................................Universal
Updated Outline Dimensions........................................................16
Changes to Ordering Guide...........................................................16
5 V Only Stereo DAC for Multimedia..................................... 13
Low Voltage Headphone Amplifiers........................................ 14
Low Noise Microphone Amplifier for Multimedia ............... 14
3 V 50 Hz/60 Hz Active Notch Filter with False Ground .....14
Low Voltage Frequency Synthesizer for Wireless
Transceiver ..................................................................................15
Outline Dimensions....................................................................... 16
Ordering Guide .......................................................................... 16
Revision 0: Initial Version
2/02—Rev. B to Rev. C
dits to FEATURES...........................................................................1
E
Edits to GENERAL DESCRIPTION...............................................1
Edits to SPECIFICATIONS......................................................... 2–3
Edits to Package Type........................................................................4
Edits to ORDERING GUIDE...........................................................4
Edits to ABSOLUTE MAXIMUM RATINGS ...............................4
Edits to OUTLINE DIMENSIONS...............................................12
Rev. D | Page 2 of 16
OP183
www.BDTIC.com/ADI
SPECIFICATIONS
ELECTRICAL CHARACTERISTICS @ VS = 5 V
TA = 25°C, unless otherwise noted.
Table 1.
Parameter Symbol Conditions Min Typ Max Unit
INPUT CHARACTERISTICS
Offset Voltage VOS V
−40°C ≤ TA ≤ +85°C 1.25 mV
Input Bias Current IB V
−40°C ≤ TA ≤ +85°C 430 750 nA
Input Offset Current IOS V
−40°C ≤ TA ≤ +85°C 11 ±50 nA
Input Voltage Range 0 3.5 V
Common-Mode Rejection Ratio CMRR VCM = 0 to 3.5 V
Large Signal Voltage Gain AVO R
Offset Voltage Drift ΔVOS/ΔT 4 μV/°C
Bias Current Drift ΔIB/ΔT −1.6 nA/°C
OUTPUT CHARACTERISTICS
Output Voltage High VOH R
Output Voltage Low VOL R
Short-Circuit Limit ISC Source 25 mA
Sink 30 mA
POWER SUPPLY
Power Supply Rejection Ratio PSRR VS = 4 V to 6 V,
Supply Current/Amplifier ISY V
Supply Voltage Range VS
DYNAMIC PERFORMANCE
Slew Rate SR RL = 2 kΩ 5 10
Full Power Bandwidth BWp 1% Distortion
Settling Time tS To 0.01%
Gain Bandwidth Product GBP
Phase Margin фm
NOISE PERFORMANCE
Voltage Noise en p-p 0.1 Hz to 10 Hz
Voltage Noise Density en f = 1 kHz, VCM = 2.5 V
Current Noise Density in
= 2.5 V, V
CM
= 2.5 V, V
CM
= 2.5 V, V
CM
−40°C ≤ TA ≤ +85°C
= 2 kΩ, 0.2 ≤ VO ≤ 3.8 V 100 V/mV
L
= 2 kΩ to GND 4.0 4.22 V
L
= 2 kΩ to GND 50 75 mV
L
= 2.5 V, 0.025 1.0 mV
OUT
= 2.5 V, 350 600 nA
OUT
= 2.5 V, nA
OUT
70 104 dB
−40°C ≤ T
= 2.5 V,
O
−40°C ≤ T
≤ +85°C 70 104
A
≤ +85°C
A
3
1.2 1.5 mA
>50
1.5
5
46
2
10
0.4
dB
±18 V
V/μs
kHz
μs
MHz
Degrees
μV p-p
nV/√Hz
pA/√Hz
Rev. D | Page 3 of 16
OP183
www.BDTIC.com/ADI
ELECTRICAL CHARACTERISTICS @ VS = 3 V
TA = 25°C, unless otherwise noted.
Table 2.
Parameter Symbol Conditions Min Typ Max Unit
INPUT CHARACTERISTICS
Offset Voltage VOS V
Input Bias Current IB V
Input Offset Current IOS V
Input Voltage Range
Common-Mode Rejection Ratio CMRR VCM = 0 V to 1.5 V,
Large Signal Voltage Gain AVO R
OUTPUT CHARACTERISTICS
Output Voltage High VOH R
Output Voltage Low VOL R
Short-Circuit Limit ISC Source
POWER SUPPLY
Power Supply Rejection Ratio PSRR VS = 2.5 V to 3.5 V,
Supply Current/Amplifier ISY −40°C ≤ TA ≤ +85°C, VO = 1.5 V
DYNAMIC PERFORMANCE
Gain Bandwidth Product GBP
NOISE PERFORMANCE
Voltage Noise Density en f = 1 kHz, VCM = 1.5 V
= 1.5 V, V
CM
−40°C ≤ T
= 1.5 V, V
CM
−40°C ≤ T
= 1.5 V, V
CM
−40°C ≤ T
= 1.5 V,
OUT
≤ +85°C
A
= 1.5 V,
OUT
≤ +85°C
A
= 1.5 V,
OUT
≤ +85°C
A
0.3 1.0 mV
1.25 mV
350 600 nA
750 nA
0
11 ±50 nA
1.5 V
nA
−40°C ≤ T
= 2 kΩ, 0.2 ≤ VO ≤ 1.8 V 100 260
L
≤ +85°C 70 103
A
dB
V/mV
= 2 kΩ to GND 2.0 2.25
L
= 2 kΩ to GND
L
Sink
90 125 mV
25
30
V
mA
mA
−40°C ≤ T
≤ +85°C 60 113
A
1.2 1.5 mA
dB
5
MHz
10
nV/√Hz
Rev. D | Page 4 of 16
OP183
www.BDTIC.com/ADI
ELECTRICAL CHARACTERISTICS @ VS = ±15 V
TA = 25°C, unless otherwise noted.
Table 3.
Parameter Symbol Conditions Min Typ Max Unit
INPUT CHARACTERISTICS
Offset Voltage VOS
Input Bias Current IB
Input Offset Current IOS −40 ≤ TA ≤ +85°C
Input Voltage Range
Common-Mode Rejection Ratio CMRR VCM = −15 V to +13.5 V,
Large Signal Voltage Gain AVO R
Offset Voltage Drift ΔVOS/ΔT
Bias Current Drift ΔIB/ΔT
Long-Term Offset Voltage VOS Note
OUTPUT CHARACTERISTICS
Output Voltage High VOH
Output Voltage Low VOL
Short-Circuit Limit ISC Source
Open-Loop Output Impedance Z
POWER SUPPLY
Power Supply Rejection Ratio PSRR VS = ± 2.5 V to ± 18 V,
Supply Current/Amplifier ISY V
Supply Voltage Range VS
DYNAMIC PERFORMANCE
Slew Rate SR RL = 2 kΩ 10 15
Full Power Bandwidth BWp 1% Distortion
Settling Time tS To 0.01%
Gain Bandwidth Product GBP
Phase Margin фm
NOISE PERFORMANCE
Voltage Noise en p-p 0.1 Hz to 10 Hz
Voltage Noise Density en f = 1 kHz
Current Noise Density in
1
Long-term offset voltage is guaranteed by a 1,000 hour life test performed on three independent lots at 125°C, with an LTPD of 1.3.
−40°C ≤ T
A
−40°C ≤ T
A
≤ +85°C
≤ +85°C
−15
0.01 1.0 mV
1.25 mV
300 600 nA
400 750 nA
11 ±50 nA
+13.5 V
–40°C ≤ TA ≤ +85°C 70 86
= 2 kΩ 100 1000
L
1
3
−1.6
1.5 mV
dB
V/mV
μV/°C
nA/°C
RL = 2 kΩ to GND, −40°C ≤ TA ≤ +85°C
RL = 2 kΩ to GND, −40°C ≤ TA ≤ +85°C
Sink
f = 1 MHz, AV = +1
OUT
13.9 14.1
−14.05 −13.9 V
30
50
15
V
mA
mA
Ω
−40°C ≤ T
= ±18 V, VO = 0 V,
S
−40°C ≤ T
≤ +85°C 70 112
A
≤ +85°C
A
3
1.2 1.75 mA
dB
±18 V
50
1.5
5
56
V/μs
kHz
μs
MHz
Degrees
2
10
0.4
μV p-p
nV/√Hz
pA/√Hz
Rev. D | Page 5 of 16
Loading...