Akai DVP4410 User Manual

Operator's manual
DVD PLAYERDVD PLAYER
DV-P4410
ON / STANDBY
POWER
Operator's manual
LEVEL PHONES
MIN MAX
STOP
MENU
ENTER
DV-P4410
DVD / MP3 / KODAK P ICTURE CD/ CD / CD-R / CD-RW P LAYER
1~20
Getting started
Dear customers:
May we take this opportunity to thank you for purchasing this DVD player. We strongly recommend that you carefully study the
operating instructions before operating the unit.
Main Features
Fully compatible with DVD, MP3,CD, CD-R and CD-RW disc.
DTS-compatible digital audio output.
Compatible with full DVD playback functions: multi-angle, multi-language,
multi-story, parental control, etc..
Advanced 10-bit/27MHz video D/A converter with over 500 lines of horizontal
resolution.
Video output: Normal video output, S-video output, 21 pin scart,
Audio output: Dolby Digital 2ch output, MPEG-II Audio output,Coaxial
digital output
24-bit/96kHz audio D/A converter.
3-step zoom/smooth scan.
NTSC/PAL TV system compatible.
Linear PCM decoding output.
and optical
Features of audio specifications
DTS (Digital Theater System) digital audio output
Dolby Digital 2ch decoding output
MPEG-II Audio output
Linear PCM audio decoding output
MP3 audio decoding output
Playback features
Skipping ahead and skipping back
Multi-speed slow motion playback
Programmable playback
Time search
Features of playback specifications
This product complies the MPEG II standardization law.
-720 X 480 £¨30Hz£©
-720 X 576 £¨25Hz£© PAL and NTSC
Before using the player, please ensure that the local AC voltage is suitable for this unit.Before using the player, please ensure that the local AC voltage is suitable for this unit.
3-step zooming playback
3-way repeat playback
Numeric selection
Getting started
Getting startedGetting started
Disc types
Disc size 12cm Single side, single layer /single side,
Audio & Video
Audio
double layer PAL and NTSC DVD disc Playback time 135min/240min max.
Disc size 12cm/8cm CD disc Playback time 74min/20min max
Disc maintenance
-Before playback, wipe the disc from the center hole toward the outer edge with a clean cloth.
Table of contents
Getting Started
Features
Disc types & maintenance
Safety precautions
Accessories and remote control unit
System connection
Front panel
Basic operation
Starting playback and function buttons
Searching buttons and other buttons
MP3 & JPEG operations
Playback mode
Menu and program
P1-P6
P1 P2
P3
P4
P5
P6
P7-P8
P7
P8
P9
P11
P13
Basic operationBasic operation
operations
MP3/JPEG
operations
MP3/JPEG
mode
Playback
mode
Playback
program
Menu &
program
Menu &
settings
Initial
settings
Initial
TroubleshootingTroubleshooting
WrongRight
-Never use benzine, thinner, cleaning fluid, static electricity prevention liquids or any other solvent.
Dirty disc may cause bad picture.
Initial settings
Troubleshooting tips
Definition of terms
P14
P17
P18
TermsTerms
2
Getting started
Safety precautions
WARNING WARNING WARNING
To avoid electrical shock, do not open the cabinet, refer servicing to qualified personnel only.
ATTENTION ATTENTIONATTENTION
Touching the unit is dangerous, If thunder.
ATTENTION
If smoke, malodor or noises are emitted from the unit, turn off the power and disconnect the AC power cord.
When left unused for a long period of time, the unit should be unplugged from the household AC outlet.
Keep the unit away from flower vases, tubs, sinks, etc.. If liquids are spilled into the unit, serious damage could occur.
WARNING
Do not block ventilation holes of the unit so that air can circulate freely.
Do not expose this equipment to rain or moisture.
Be sure to turn the unit off and dis­connect the AC power cord before cleaning the unit surface . If the surface is dirty, wipe clean with a cloth which has been dipped in a weak soap-and -water solution and wrung out thoroughly, and then wipe again with a dry cloth.
3
Notes: This unit is a class 1 laser product and uses a visible laser beam which could cause hazardous radiation exposure if directed. Be sure to operate it correctly as instructed.
The above items are true of not only this unit but also most of the household electronic products.
Getting Started
Accessories
Audio cord
Remote control unit
Batteries (size AAA, R03, UM-4)
Video cord
Battery installation(remote control unit)
Remove the battery cover.
1.
2.
Insert two batteries(AAA, R03, UM-4 type) making sure the polarity(+/-) matches the marks inside the unit.
Remote control unit
PBC
+&-
P.12
P.7
P.12
P.13
P.14
P.1 1 P.14
P.8
P.7
P.1 1 P.1 1 P.1 1 P.1 1 P.12
P.12
P.8
SYSTEM
POWER
MENU
ZOOM
ENTER
SLOW
FAST FORWARD
FAST BACKWARD
REPEAT REP A-B
MUTE
GO TO
P.12
P.7
P.13
P.9
P.13 P.12
P.1 1
P.1 1
P.12
P.12
OSD
CLEAR
STEP
PROGRAM RANDOM
RESUME
FUNCTION
L/R
3.
Replace the cover.
--Do not attempt to recharge, short-circuit, disassemble, heat or throw the batteries into the fire.
--Do not mix old and new batteries.
Weak batteries can leak and severely damage the remote control unit.
Point remote control unit no more than 8m from the remote sensor and within about 60 of the front of the unit.
4
Loading...
+ 10 hidden pages