3D Robotics Y6 Ready-to-Fly User Manual
Y6
Unfold arms and legs1
Remove the bolts and nuts outside the blue arms.
Rotate the blue arms into position, and secure the
arms in place with the same bolts and nuts.
Remove
Slide arms into
position
front arms
(blue)
Secure with bolt
rear arm
(black)
travel position
Rotate the legs into place and secure through the
inner hole with the provided bolt and nut.
travel position
flight position
flight position
Attach propellers2
Remove the rings from the propeller
packages. Select the ring with the
smaller internal diameter, and insert
it into the back of the propeller hub.
Remove the nuts and washers from the motors.
Add SFP propellers to the top-front motors and
SF propellers to the bottom-front motors with
the writing facing towards the sky. For the rear
arm, attach an SF propeller to the top motor
and an SFP propeller to the bottom motor. Make
sure the writing on the propellers faces the sky!
Place the washer over the propeller, and
secure the nut tightly on top. Always ensure
that the propellers are fastened tightly to
the motors before flying.
Charge battery3
Connect the charger to the power
adapter cable and a wall outlet.
Connect the red cable to the + port
and the black cable to the - port.
SFP
SF
SF
SFP
+
SFP
SF
red
black
–
Set the charger to LiPo and 3A.
LiPo 3A
Connect the white connector to
the 3S port. Join the two yellow
connectors together.
Secure battery inside the guard
bag while charging. Charge until
the status indicator displays green.
red green
Charging Complete
guard bag
3S
!
Battery safety
Protect battery from extreme heat, extreme cold, puncturing,
and flammable surfaces. Always transport, charge, and store
the battery in the guard bag.
Charge battery using a designated LiPo balance charger only.
Always monitor battery while charging.
Flying with a low battery is a safety risk and can render the
battery unusable. Always discontinue use when you receive a
low battery notification, and always fly with a fully charged battery.
Inspect battery for damage before takeo and after landing.
If you observe any swelling of the package or the battery ceases
to function, locate your local battery recycling center to dispose
of the battery. In the US and Canada, visit call2recycle.org to
find a location. Do not dispose of the battery in the trash.
Loading...