YEALINK W56H Users Manual

Yealink IP DECT Phone

W56P & W56H

www.yealink.com

Quick Start Guide(V80.1)

Applies to firmware version 25.80.0.1 or later.

Packaging Contents

Packaging Contents

The following items are included in your W56P package:

Handset

Belt Clip

Base Station

Ethernet Cable

Charger Cradle

Rechargeable Battery

Two Power Adapters

Quick Start Guide

The following items are included in your W56H package:

Handset

Note: We recommend that you use the accessories provided or approved by Yealink. The use of unapproved

third-party accessories may result in reduced performance.

Assembling the DECT Phone

Assembling the Phone

Charger Cradle

Power Adapter

Belt Clip

Rechargeable Battery

1. Connect the network and power for the base station in one of the following ways, as shown below:

a. AC Power Option

b. PoE (Power over Ethernet) Option

IEEE 802.3af compliant
PoE Hub/Switch

If inline power (PoE) is provided, you do not need to connect the power adapter. Make sure the hub/switch is

Note:

PoE-compliant. The base station should be used with original power adapter (5V/600mA) only. The use of
the third-party power adapter may cause the damage to the base station.

1

2. Insert the battery into the handset, as shown below:

battery

3. Connect the charger cradle and charge the handset, as shown below:

Note:

The handset should be used with original power adapter (5V/600mA) only. The use of the third-party power
adapter may cause the damage to the handset.
The charging status of the handset is indicated in the top right-hand corner of the LCD screen.

4. (Optional) Mount the charger cradle on the wall, as shown below:

36.00mm

1:1

5. Attach the Belt Clip, as shown below:

36mm

2