Yamaha Tenere 700 2020-2021 Installation Manual

POWER COMMANDER V

2020-2021 Yamaha Tenere 700
Installation Guide

PARTS LIST

1 POWER COMMANDER V

1 INSTALLATION GUIDE

1 USB CABLE

2 VELCRO STRIPS

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

2 DYNOJET DECALS

2 POWER COMMANDER DECALS

1 ALCOHOL SWAB

22-096

POWER COMMANDER V INPUT ACCESSORY GUIDE

USB CONNECTION

CRANK

ANALOG

SPEED

EXPANSION PORTS 1 & 2

Optional Accessories such
as POD-300 unit or Auto­tune kit.

INPUT 2 (Grnd)

INPUT 2

INPUT 1 (Grnd)

INPUT 1

ACCESSORY INPUTS:

Map - (Input 1 or 2) The PCV has the ability to hold 2 different base maps. You can switch on the fly between these two

base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity
of the wires is not important. When using the Autotune kit one position will hold a base map and the other
position will let you activate the learning mode. When the switch is “CLOSED” Autotune will be activated.

Shifter- (Input 1 or 2) These inputs are for use with the Dynojet quickshifter. Insert the wires from the Dynojet

quickshifter into the SHIFTER inputs. The polarity of the wires is not important.

Speed- If your application has a speed sensor then you can tap into the signal side of the sensor and run a wire into this

input. This will allow you to calculate gear position in the Control Center Software. Once gear position is setup
you can alter your map based on gear position and setup gear dependent kill times when using a quickshifter.

Analog- This input is for a 0-5v signal such as engine temp, boost, etc. Once this input is established you can alter your

fuel curve based on this input in the control center software.

Crank- Do NOT connect anything to this port unless instructed to do so by Dynojet. It is used to transfer crank trigger

data from one module to another.

WIRE CONNECTIONS:

To input wires into the PCV first remove the rubber plug on the backside
of the unit and loosen the screw for the corresponding input. Using a
22-24 gauge wire strip about 10mm from its end. Push the wire into the
hole of the PCV until is stops and then tighten the screw. Make sure to
reinstall the rubber plug.

NOTE: If you tin the wires with solder it will make inserting them easier.