Yaesu zcut-3150, zcut-3250 Instruction Manual

YAESU KEIKOGYO CO., LTD.

IDENTIFICATION OF PARTS

2

①

②

8

7

12

13

11

15

1

2

3

4

5

10

9

14

6

TAPE (not include)

1. POWER SWITCH 2.TAPE LENGTH COUNTER

3. AUTO / MANUAL SWITCH 4. INTERVAL ADJUSTMENT KNOB

5. OVER LOAD ALARM LAMP 6. PANEL SWITCH

7. SAFETY LID 8. HOOK

9. TAPE OUTLET 10. FRONT PANEL HOOK

11. FRONT PANEL 12. ROLLER

13. SILICON SPONGE ROLLER 14.BOBBIN

15. TAPE GUIDE

1)

3)

8)

surface

adhesive side

3

13 SILICON SPONGE ROLLER

12 ROLLER

10 FRONT PANEL HOOK

7)

9)

2)

INTRODUCTION

Thank you for purchasing our Automatic Tape Dispenser.
Our product is produced for industrial use.
Please read this Instruction Manual careflly and become familier with
machine before handling it.

BEFORE USE

1) Before you plug in the cord, make sure that the Power Switch 1 is off.

2) Set the Tape Length Counter 2 for more than 200mm.

■If you this for less than 200mm, the tape would not come out smoothly.

3) Set the Auto/Manual Switch 3 for Manual.

4) Plug into an outlet firmly.

5) Turn the Power Switch 1 on.

6) Put a tape onto the Bobbin 14.

7) Open the Safty Lid 7.

8) Extend the tape and fold the edge of tape about 20-30mm to the sticky side.

■If the tape has no glue, it is not necessary.

9) Insert the tape between the Roller 12 and the Silicon Sponge Roller 13.

10) Tap the Panel Switch 6 upwards once lightly.

11) Cut two or three pieces to make sure that tape comes out from the Tape Outlet 9.

12) Make sure that the tape is coming out smoothly, then close the Safety Lid 6.

■If the tape winds around the other Roller, please turn the Power Switch 1 off, remove the Front
Panel Hook 10 and open the panel.
Cut the wound up the tape off and start again.

■Whenever cut the wound up the tape off, extreme care for do not scratch the roller.

13) Set the tape length as you like.
Anytime you set the length, the Power Switch 1 must be off.