Xerox DocuPrint C55, DocuPrint C55mp User Manual

Printer Relocation

If you need to relocate your printer, read the following descriptions to
decide which type of move you are performing.

x

Simple Move If you are moving your printer within the same building
and there are no major obstacles such as stairs, a very rough floor
surface use the Simple Move procedure provided in this document.

x

Complex Move If the printer will be transported in a motor vehicle to
the new site it is recommended you use the Xerox Repack Kit to avoid
damage to the printer during the move. You can order the Repack Kit
from your dealer or Xerox.

CAUTION: Properly preparing the printer for a move will avoid
possible permanent damage to your printer.

Simple Move

PREPARE THE PRINTER

Warning: After turning off the printer, allow the Fuser to cool to a safe
temperature before handling.

1. Press the printer power switch to OFF.

2. Disconnect the power cord and any network interface or port cables.

3. Open the front shell and remove the Toner Collector. Retain this part

for reinstallation.

4. Open the top cover and remove the Fuser assembly. Pack this in a
separate box. It is important to not allow it to tip as oil can collect in
hidden areas and this may result in an oil spill.

5. Close all covers.

MOVE THE PRINTER

CAUTION: Keep the printer level at all times during relocation.
Tipping or tilting the printer may cause the dry ink (toner) and
developer to shift in the cartridges, causing printing defects.

1. Ensure that two people lift and carry the printer. Be careful when
lifting the printer as it weighs over 80 pounds (39 kg). Use a flat cart if
possible to transport the printer to the new location.

2. Place the printer on a firm, level surface. Arrange the printer to allow
room for any panels to be opened, covers to be removed, and the
Manual Feed tray to be installed.

REINSTALL THE PRINTER

1. Connect the power cable to the rear of the printer and any network
interface or port cables.

2. Open the front shell and replace the Toner Collector.

3. Open the top cover and replace the Fuser assembly. Be sure this
assembly is free of spilled oil.

4. Close all covers

5. Press the printer power switch to ON.

6. Access the <PRINT> menu and print one of the settings pages as a test
print.

CAUTION: Allow the printer to stabilize for several hours before
making any adjustments.