Whirlpool ART 303/4/G-L, ART 308/DT-V, ART 303/4/G-R, ART 316/DT-H, ART 316/DT-V User Manual

...

0 (0)

INDEX		GB

BEFORE USING THE APPLIANCE	PAGE 16

INSTALLATION	PAGE 17

CONNECTING THE MINI-KITCHEN	PAGE 18

PRECAUTIONS AND GENERAL
RECOMMENDATIONS	PAGE 20

REFRIGERATOR

USE OF THE REFRIGERATOR	PAGE 21

ELECTRIC HOTPLATES

USE OF THE ELECTRIC HOTPLATES	PAGE 23

USE OF THE TIMER	PAGE 24

ADVICE

CLEANING AND MAINTENANCE	PAGE 25

TROUBLESHOOTING GUIDE	PAGE 26

AFTER-SALES SERVICE	PAGE 27

Refrigerator with	,	compartment and
automatic defrost.

The rated performance is obtained with the appliance operating at ambient temperatures between +16°C and +32°C.

The single appliances of the Mini-kitchen are in compliance with VDE regulations, EEC international directives, EEC directive

no. 87/308/CE relating to the suppression of radio interference, and with current safety standards.

The refrigerator has been tested for fluidtightness and conforms to VBG 20 accident prevention standards for cooling systems.

To install an extractor hood...

observe the minimum distance from the hotplates! Minimum distance between electric hotplates and lower edge of extractor hood: 650 mm. For reasons of safety this distance must absolutely be maintained!

BEFORE USING THE APPLIANCE

In purchasing this new product you have chosen a household appliance capable of matching the highest expectations from a technical standpoint and affording an ease of use compatible with practical requirements.

This new appliance offers you all that is technically possible at the time of its design and manufacture.

Your appliance is particularly economic in terms of energy consumption and therefore environment friendly, if used responsibly.

If treated properly, it will give you dependable service for many years.

To get the most out of your new appliance, read the user handbook thoroughly. You will find a full description of the various components.

Keep this handbook for future consultation.

Information:

This appliance uses neither CFCs (refrigeration circuit contains R134a) nor HFCs (refrigeration circuit contains R600a - Isobutane). For more information, refer to the data plate affixed to the appliance.

Important In the past, the doors of refrigerators and freezers were often equipped with spring catch or bolt type locks. If a machine of this type is to be scrapped and disposed of, destroy the lock to ensure children cannot trap themselves inside and put their lives at risk!

Having unpacked the equipment, make sure no part of it has suffered damaged. Any damage must be reported to your dealer within 24 hours after taking delivery of the appliance.

Wait at least two hours before connecting the appliance to the power supply in order to ensure the refrigerant circuit is fully efficient.

SAFEGUARDING THE ENVIRONMENT

Packing

The packing material is entirely recyclable, and marked with the recycling symbol . Follow local disposal regulations.

Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.

Appliance

The appliance is made from recyclable materials. If you decide to scrap the appliance, it must be disposed of in compliance with local waste disposal laws.

Make the appliance unusable by cutting off the power cord. The appliance must be consigned to an authorised collection centre for the recovery of refrigerant gas.

INSTRUCTIONS

INSTRUCTIONS FOR USE

These indications contain important information on the use of your appliance. There may be differences in detail, depending on the model.

INSTALLATION

Before installation, make sure that the tubes on
the rear of the refrigerator have not been bent in
transit. If the tubes touch the refrigerator or the
wall, the refrigerator will be irritatingly noisy
during operation.
If necessary, bend them carefully to restore the
correct clearance.
The Mini-kitchen must be installed in a fixed and
plumb upright position. Any unevenness of the
floor can be accommodated by adjusting the feet
(fig. 1).	Fig. 1

Warm air must be free to escape unobstructed at the rear of the refrigerator so as not to affect operation (and not to cause increased electrical power consumption). Accordingly, the ventilation slots behind the hotplates must not be covered.

The machine is approved only for freestanding installation against a wall. Items of furniture may be placed adjacently on either side.

Whirlpool ART 303/4/G-L, ART 308/DT-V, ART 303/4/G-R, ART 316/DT-H, ART 316/DT-V User Manual

CONNECTING THE MINI-KITCHEN

Connections to the water supply and waste pipelines should be made preferably by a professional installer.

The Mini-kitchen is designed for connection to the earthed socket outlet of a 220-230 V/50 Hz supply, provided with an isolating contact in compliance with current safety regulations.

The Mini-kitchen with electric hotplates must be protected by a 16 A fuse. The Mini-kitchen can be converted by a qualified installer for operation at 380-400 V 2 n 750 Hz.

In this case a 10 A fuse is required.

Important! In the case of a fixed electrical installation of the Mini-kitchen, the installer must fit a multi-pole switch with a gap between open contacts of at least 3 mm, or an automatic circuit breaker.

This multi-pole isolating device must be fitted even if the plug is no longer accessible after the appliance has been installed.

• Important for appliances operating off

380-400 V (CH) supply.

The Mini-kitchen must be connected by the installer to the 380-400 V 250 Hz supply, fitting a 10 A fuse and a multi-pole switch with gap between open contacts of at least 3 mm, or an automatic circuit breaker.

+ 9 hidden pages