Weller WSD130 User Manual

NOTES

S2032ACH
8/98
Rev. 11/01

WSD130 SOLDERING STATION

1. Power Switch

2. Digital Display

3. “UP” Button

4. “DOWN” Button

5. Optical Regulator, Right

6. Connection for Soldering Iron, Right

7. Selection Switch

8. Connection for Soldering Iron, Left

9. Optical Regulator, Left

10. Power Supply Connection

11. Fuse/Holder

WARNING:
This product, when used for soldering and

similar applications, produces chemicals
known to the State of California to cause
cancer and birth defects or other reproductive
harm.

1

DESCRIPTION
CONTROL UNIT

The WSD130 Soldering Station belongs to a family of equipment developed for Industrial production as well for the repair
and laboratory sectors. Simple and easy operation is made possible by the use of a microprocessor. Two different
soldering irons can be operated at the same time on two independent digital temperature regulators. The soldering irons
themselves are automatically identified by the soldering station and assigned the appropriate control parameters. The
particularly powerful 24 V heater elements provide excellent, dynamic behavior making the soldering irons universal in
their application.

A grounded soldering iron tip, a zero voltage switch, as well as anti-static features on the control unit and soldering irons,
supplement the high standard of quality. The functional diversity of this soldering station is further expanded by the
possibility of connecting an additional input unit. Using the optional WCB1 and WCB2 Input Units, timing and locking
functions, among others, can be realized. An integrated temperature measurement unit and PC interface are included in
the extended scope of the WCB2 Input Unit.

The required temperature can be adjusted over the range 150°F - 850°F using the Up/Down keys. The set point and
actual value are digitally displayed by making the appropriate selection using the channel button. Achievement of the pre­set temperature is indicated by an LED assigned to the channel; this LED thus serves as an optical regulator monitor.
Continuous illumination means that the system is warming up.

NOTE: The WSD130 can also power and control most Weller Desoldering Irons. However, do not attempt to use two

desoldering irons on one WSD130 control unit. You may use two WSP80 irons, or one WSP80 and one DS
desoldering iron at the same time. If the applied load is such that the heater power remains full on for 20
minutes, the heater power will be reduced to 90%.

WSD130 EXPLODED VIEW

2

11