Weider PRO OLYMPIC EXPANSION KIT Owner's Manual
Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until
assembly is completed. Assembly requires two adjustable wrenches .
Model No. 831.150780
QUESTIONS? If you have questions, or if there are missing or damaged parts, please call our toll-free
HELPLINE at 1-800-736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).
Assembly Instructions
Olympic Expansion Kit
If you own the 831.150740 (WEIDER PRO 800), follow
steps 1 through 6 below and on page 2 to install the
olympic expansion kit. If you own the 831.150760
(WEIDER PRO 900), follow steps 1 through 6 on page
3 and the back cover.
1. Detach the Crossbar (A) from one of the Upright
Bases (B) by removing the four M10 x 81mm Bolts
(C), the Support Plates (D), and the four M10 Nylon
Locknuts (E). Lay the Upright Base on its side to
keep it from falling.
1
E
D
B
C
A
E
C
D
2. Detach the Frame (F) from the Crossbar (A) by
removing the two M10 x 81mm Bolts (C), the Small
Support Plate (G), and the two M10 Nylon Locknuts
(H).
Note: It may be helpful to have a second person
hold the remaining Upright Base (B) to keep it
from falling.
2
A
F
E
B
C
G
H
ยจ
1. Read all instructions in this manual before
using the olympic expansion kit.
2. The weight bench does not include weights.
The weight bench is designed to support a
maximum of 510 pounds, including the user, a
weight bar, and weights. Do not place more that
310 pounds, including a weight bar and weights,
on the weight rests. Do not place more that 150
pounds on the leg lever or the lat tower.
To reduce the risk of serious injury, read the following important precautions
before using the weight bench.
WARNING:
2
4. Attach the Frame (F) to the Olympic Crossbar (I) with
two M10 x 81mm Bolts (C), a Small Support Plate
(G), and two M10 Nylon Locknuts (H).
5. Attach the other side of the Olympic Crossbar (I) to
the other Upright Base (B) with the remaining four
M10 x 81mm Bolts (C), the Support Plates (D), and
the four M10 Nylon Locknuts (E).
6. Press the Bushings (J) into the ends of the Weight
Adapter (K) as shown. Slide the Weight Adapter onto
the Weight Tube (L) and secure it by pushing the
Detent Pin (M) into the weight tube as shown.
6
M
L
J
K
I
F
E
C
G
H
4
E
D
B
C
I
E
C
D
5
3. Detach the Crossbar (A) from the other Upright Base
(B) by removing the remaining M10 x 81mm Bolts
(C), Support Plates (D), and M10 Nylon Locknuts
(E).
Attach the Olympic Crossbar (I) to the Upright Base
(B) with four M10 x 81mm Bolts (C), two Support
Plates (D), and four M10 Nylon Locknuts (E).
Store the standard Crossbar (A) in a safe place.
3
A
E
C
D
D
B
I
C
E
Loading...