VTech i6725 User Manual
Quick Start Guide
i6725
STEP 1 Check package contents
Make sure your phone’s packaging includes the following:
STEP 3 Battery installation
1. Ali gn the two hol es in the plug with th e socke t pins,
then snap the plug into place. Place the battery in the
compar tment with the wires in the upper right corner.
2. Replace cover by sliding it upwards until it cli cks into
place.
STEP 5 Connect to phone line
Plug one end of the telephone line cord into the telephone line
jack at the bottom of the telephone base. Then plug the other
end of the cord into the wall telephone outlet.
NOTE:
For complete feature instructions, please refer to your
user’s manual.
IMPORTANT!
If your product is not working properly:
1. Refer to your user’s manual.
2. Vi sit our web si te at w ww.vtechph on es .com or ww w
vtechcanada.com in Canada.
3. Call our customer service at 1-800-595-9511 or 1-800 -267
7377 in Canada.
Charger power adaptor
Base unit
Telephone
line cord
STEP 2
Plug the power adaptor into an electrical outlet not controlled
by a wall switch, and the connector into the power jack on
bottom of the telephone base/charger.
Handsets (2)
bracket
Charger
Belt clips (2)Wall mount
Connect power to telephone base/charger
Base power adaptor
Batteries (2)
Quick start
guide
User’s manual
STEP 4 Charge the battery
1. Place the handset in the base unit/charger.
2. Chargethebatteryforatleast16hoursbeforerstuse.
STEP 6 Making and receiving calls
Making a call
• Press TALK/ FL ASH or SPEAKER and li sten for dial
tone.
• Dial the phone number.
-OR-
• Dial the phone number.
• Press
Receiving a call
Press TALK/FLASH, SPEAKERPHONE, or any dialing key
except OFF.
TALK/FLASH.
NOTE:
• Use only the power adaptors supplied with your
VTech telephone.
Hanging up
Press OFF or place the handset in its
base/charger.
96-006081-010-000
Issue 0
Loading...