VTech Go! Go! Smart Wheels Fire Truck Owner's Manual

Go! Go! Smart Wheels™ Fire Truck

User’s Manual

BATTERY INSTALLATION

1. Make sure the unit is turned OFF.

2. Locate the battery cover on the bottom of the
unit. Use a coin or a screwdriver to loosen the
screw.

3. Install 2 new “AAA” (AM-4/LR03) batteries
following the diagram inside the battery
box. (The use of new alkaline batteries is
recommended for maximum performance.)

4. Replace the battery cover and tighten the
screw to secure.

WARNING: All packing materials, such

as tape, plastic sheets, packaging locks and tags are
not part of this toy, and should be discarded for your
child’s safety.

Attention : Pour la sécurité de votre enfant, débarrassez-vous

de tous les produits d’emballage tels que rubans
adhésifs, feuilles de plastique, attaches et étiquettes.
Ils ne font pas partie du jouet.

NOTE: Please keep user’s manual as it contains important

information.

PRODUCT FEATURES

1. ON/OFF SWITCH

To tu rn the unit ON , slid e the ON/OF F

SWITCH to the ON (

the unit OFF, slide the ON/OFF SWITCH to
the OFF (

) position.

) position. To turn

2. AUTOMATIC SHUT-OFF

To preserve battery life, the VTech® Go! Go! Smart WheelsTM Fire Truck

will automatically power-down after approximately 60 seconds without input.
The unit can only be turned on again by pressing the light-up driver button or

pushing the fire truck quickly.

Note: This product is in a try-me mode in the packaging. After opening the package,

turn the vehicle off and on again to proceed with normal play.

NOTE : Ce produit est actuellement en mode démonstration. Une fois déballé,
veuillez éteindre puis remettre en marche ce jouet pour activer toutes ses

fonctionnalités.

ACTIVITIES

1. Slide the ON/OFF SWITCH to turn the unit ON.

You will hear fire truck sounds, a song and a

phrase. The light will flash with the sounds.

BATTERY NOTICE

• Use new alkaline batteries for maximum performance.

• Use only batteries of the same or equivalent type as recommended.

• Do not mix different types of batteries: alkaline, standard (carbon-zinc) or
rechargeable (Ni-Cd, Ni-MH), or new and used batteries.

• Do not use damaged batteries.

• Insert batteries with the correct polarity.

• Do not short-circuit the battery terminals.

• Remove exhausted batteries from the toy.

• Remove batteries during long periods of non-use.

• Do not dispose of batteries in fire.

• Do not charge non-rechargeable batteries.

• Remove rechargeable batteries from the toy before charging (if removable).

• Rechargeable batteries are only to be charged under adult supervision.

1

2. Press the L IGHT-UP DRIVER BUTTON to

hear fire truck sounds, songs and phrases.

The light will flash with the sounds.

3. Push the fire truck to hear fun sounds and

melodies. While the melody is playing, push

the fire truck again to add in fun sounds on
top of the melody. The light will flash with the
sounds.

2

4. For added fun, the fire truck interacts with

oth er VTe ch
playsets. Simply roll the fire truck over one of
the playset’s SmartPoint™ locations to see the

fire truck’s light flash and to hear greetings,
fun sounds, short tunes and sing-along songs

(each playset sold separately).

®

Go! Go! Sma rt Whee lsTM

CARE & MAINTENANCE

1. Keep the unit clean by wiping it with a slightly damp cloth.

2. Keep the unit out of direct sunlight and away from any direct heat source.

3. Remove the batteries when the unit is not in use for an extended period of time.

4. Do not drop the unit on hard surfaces and do not expose the unit to moisture

or water.

TROUBLESHOOTING

If for some reason the program/activity stops working or malfunctions, please
follow these steps:

1. Please turn the unit OFF.

2. Interrupt the power supply by removing the batteries.

3. Let the unit stand for a few minutes, then replace the batteries.

4. Turn the unit ON. The unit should now be ready to play again.

5. If the product still does not work, replace with a new set of batteries.

If the problem persists, please call our Consumer Services Department at 1-800­521-2010 in the U.S. or 1-877-352-8697 in Canada, and a service representative

will be happy to help you.

For information on this product’s warranty, please call VTech
the U.S. or 1-877-352-8697 in Canada.

IMPORTANT NOTE:

Creating and developing Infant Learning products is accompanied by a
responsibility that we at VTech

ensure the accuracy of the information, which forms the value of our products.
However, errors sometimes can occur. It is important for you to know that we

stand behind our products and encourage you to call our Consumer Services

Department at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, with

any problems and/or suggestions that you might have. A service representative
will be happy to help you.

®

take very seriously. We make every effort to

®

1-800-521-2010 in

Note:

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected

• Consult the dealer or an experienced radio/TV technician for help

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION

IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT

MAY CAUSE UNDESIRED OPERATION.
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.
CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME

NMB-003 DU CANADA.

Caution: changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

3

4

91-002543-010