TRENDnet TV-IP104D2 Quick Installation Manual

Quick Installation Guide

TV-NVR104 / TV-IP104D2 (V1.1)

Table of Content

1 English

1. Before you start

2. Hardware Drive Installation (For TV-NVR104 only)

3. System Installation

4. Initial Setup

5. Setup Wizard

1. Before You Start

Package Contents

Ÿ TV-NVR104 or TV-NVR104D2

Ÿ CD-ROM (Utility & User's Guide)

Ÿ Power Adapter

Ÿ Network cables (1.8 m / 6 ft.)

Ÿ Optical Mouse

Ÿ Quick Installation Guide

Minimum System Requirements

Ÿ Monitor/TV with VGA or HDMI connection

Ÿ Hard drive (for TV-NVR104)

1

2. Hardware Drive Installation (For TV-NVR104 only)

Skip this step if you have TV-NVR104D2.

Note:

Ÿ Static electricity can damage the TV-NVR104. Before handling the unit, discharge any static electricity by touching a metal object, or use

an anti-static wrist strap.

Ÿ The TV-NVR104 supports 3.5” SATA hard drive up to 6TB.

1. Remove the four retaining screws from the bottom panel of the TV-NVR104.

2. The top cover is slotted vertically. From the back of the unit, gently slide the cover up to separate it from the lower panel.

3. Attach the SATA cable to the hard drive (not included) and control board. SATA connectors are keyed to prevent improper installation.

2