TP-Link TL-PB20000 User Manual

限用物質含有情況標示聲明書
產品元件名稱
PCB 外殼
備考1. "超出0.1 wt %" 及 "超出0.01 wt %" 系指限用物質之百分比含量超出百分比含量基準值。 備考2. "○"系指該項限用物質之百分比含量未超出百分比含量基準值。 備考3. " — " 系指該項限用物質為排除項目。
限用物質及其化學符號
鎘Cd汞 Hg六價鉻
鉛 Pb
多溴聯苯
6+
Cr
PBB
多溴二苯醚 PBDE
COPYRIGHT & TRADEMARKS
Specications are subject to change without notice. TP-Link is a registered
trademark of TP-Link Technologies Co., Ltd. Other brands and product names are registered trademarks of their respective holders.
No part of the specication may be produced in any form or by any means or
used to make any derivative such as translation, transformation, or adaptation withput permission from TP-Link Technologies Co., Ltd. Copyright @ 2020 TP-Link Technologies Co., Ltd. All rights reserved.
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863. The original EU declaration of conformity may be found at
http://www.tp-link.com/en/ce
User Guide
Power Bank
For technical support, the user guide and other information, visit https://www.tp-link.com/support, or simply scan the QR code.
©2020 TP-Link
Charge Your Devices
Plug in the USB charging cable to the smart port, and the power bank starts charging automatically. Please charge it when the last indicator LED is blinking.
Recharge the Power Bank
Plug in your Power Bank to a wall charger or your computer's USB port via a micro-USB charging cable.
*Power adapter is NOT included.
Trickle Charging Mode
Press the Power button twice to charge small current devices, such as bluetooth earphone and wristband. The indicator LEDs will turn on in succession. Press the Power button once to exit this mode.
Notication
Image may dier from actual products.
Power Button
Safety Information
Keep the device away from water, re, humidity or hot
environments. Do not attempt to disassemble, repair, or modify the device. Do not use damaged charger or USB cable to charge the device. Do not deliberately drop or impact this device. Do not use any other chargers than those recommended. Do not disassemble, crush, puncture, short external contacts,
or dispose of the battery in re or water
Do not attempt to extrude or pierce this device, which may cause it to short circuit. If the product appears to be bulging or any other visible abnormalities, stop using the product immediately and contact us or distributor. Please recycle this device at an approved disposal location. This product is not suitable for those lacking relevant knowledge and experience, please use under the supervision and guidance of professionals. Please charge this device once every three months to avoid shortening its battery life. CAUTION:
Risk of re or explosion or defeat the safeguard of equipment
if the battery is replaced by an incorrect type. Replace only with the same or equivalent type.
Disposal of a battery into re or a hot oven, or mechanically
crushing or cutting of a battery, that can result in an explosion. High or low extreme temperatures or low air pressure at high altitude that the battery can be subjected to during use, storage or transportation. Leaving the battery in an extremely high temperature and/or low air pressure surrounding environment that can result in an
explosion or the leakage of ammable liquid or gas.
Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due to improper use of the device. Please use this product with care and operate at your own risk.
Industry Canada Statement
CAN ICES-3 (B)/NMB-3(B)
Explanation of the symbols on the product label FCC compliance information statement
Symbol Explanation
DC voltage
RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. User has the choice to give his product to a competent recycling organization or to the retailer when he buys a new electrical or electronic equipment.
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.
BSMI Notice 安全諮詢及注意事項 請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。 清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進
行清潔 。 注意防潮,請勿將水或其他液體潑灑到本產品上。 插槽與開口供通風使用,以確保本產品的操作可靠並防止過熱,請勿堵
塞或覆蓋開口。 請勿將本產品置放於靠近熱源的地方。除非有正常的通風,否則不可放
在密閉位置中。 請不要私自打開機殼,不要嘗試自行維修本產品,請由授權的專業人士
進行此項工作。
Product Name: 10000mAh Power Bank Model Number: TL-PB10000 Responsible party: TP-Link USA Corporation, d/b/a TP-Link North America, Inc. Address: 145 South State College Blvd. Suite 400, Brea, CA 92821 Website: http://www.tp-link.com/us/ Tel: +1 626 333 0234 Fax: +1 909 527 6803 E-mail: sales.usa@tp-link.com
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment. We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the equipment is properly maintained and operated.
Issue Date: 2020.5.29
Loading...