PORTABLE RADIO RECEIVER /
ПОРТАТИВНЫЙ РАДИОПРИЁМНИК
TF-1625U
Instruction manual
Руководство по
эксплуатации
Instruction manual
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.
Description
Top panel
1. TUNE/ button
2. SD/MMC memory card slot
3. /MEM-UP button
4. /TUNE button
5. USB port
6. FUNCTION/POWER button
7. VOL- button
8. VOL+ button
9. STOP/MEM-DN button
10. SNOOZE/SLEEP button
11. MEM/REP button
12. ALARM/EQ button
13. SET/LIGHT button
Back panel
1. Telescopic FM-antenna
2. Battery compartment
3. POWER ON/OFF
4. Power (DC5V) input
5. AUX input
Not indicated: display (front panel), speaker
(left and right panels)
3
STOP
MEM-DN
SNOOZE/SLEEP
9
10
4
TUNE
MEM/REP
5
11
FUNCTION/POWER
ALARM/EQ
12
6
SET
LIGHT
13
1
7
2
TUNE
MEM-UP
VOL+
VOL
-
8
1
2
POWER
OFF
+
DC5V IN
ON
AUX IN
4
3
5
2
Instruction manual
Remote controller
5
EQ
1
C/F
SNZ
ALM
6
2
MEM
3
REP
PWR
4
FUN
7
8
1. button
2. SET button
3. MEM/REP button
4. PWR/FUN button
5. C/F / SNZ button (corresponds to SNOOZE
button on the unit)
6. EQ/ALM button (corresponds to ALARM
button on the unit)
7. VOL+/VOL- buttons
8. / buttons
Utilization of the product
If you want to dispose this product, do not
mix it with general household waste. There is a
separate collection system for used electronic
products in accordance with legislation that
requires proper treatment, recovery and
recycling.
Please contact your local authorities for
the correct method of disposal. By doing so,
you will ensure that your disposed product
undergoes the necessary treatment, recovery
and recycling and thus prevent potential
negative effects on the environment and
human health.
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.
• Do not hit or drop the unit.
• Do not expose the unit to vibration, direct
sunlight, too high or low temperature or humidity.
• Do not disassemble the unit yourself.
Refer servicing to qualified service personnel.
• When the battery is exhausted, it should
be removed from the set to prevent leakage.
Power supply
Battery power
• The built-in battery used for the unit power
supply is rechargeable. The battery must be
fully charged before the first use. The first
charging time should be about 14-16 hours.
It will reach its optimal performance after fully
charged and discharged for a few times.
• To ensure the battery in optimal state,
it is recommended to discharge the battery
fully once each month at least by using up the
power so as to switch off the unit.
• In course of charging, it is normal to find
the battery and the unit warm up slightly. The
unit can automatically self-protect so as to suit
for the temperature.
Actual time of usage for the battery
varies according to operation mode.
Procedure for battery charging
• Connect the adapter to a power supply
socket, and insert the charging plug into the
Power input of the unit.
• The unit will start charging after well
connected. The power indicator will light up in
red.
3
Instruction manual
• When fully charged, the course of charging
stops automatically. Now the adaptor can be
unplugged from the unit.
To ensure safety, neither change the
parts and fitments of the battery by yourself nor
unwrap the battery. We suggest you use only
the battery and the adapter supplied with the
unit, so as not to do the damage to the unit.
Additional power
• Included are 2 AG13 batteries (1.5 V)
which are to be inserted in the terminal inside
the battery compartment. This is additional
power is intended for operation of clock, alarm,
calendar, thermometer and countdown timer.
Without the additional power the time and
alarm settings will not be stored if the unit is
switched off.
• To install the batteries, unscrew the screw
on the battery compartment on the back
panel. Make sure to observe the polarity of the
batteries
• When the batteries are exhausted they
should be replaced. New batteries should be
aquired by user. Replace the batteries only
with batteries of the same type.
ATTENTION: AG13 batteries are
consumables not covered by warranty, and
their failure (discharge) is not a ground for
addressing to service and repair centers
General operations
=> year => month => date. The selected
parameter will blink meaning readiness for
adjustment. The default time setting is 01-01,
2014, THU, 12-hour, AM12:00.
• Press TUNE/ button to adjust the
parameter up. Press /TUNE to adjust the
parameter down.
• Day of week will be set automatically.
• In time setting mode, if no button is pressed
within 10 seconds after a parameter is selected,
the unit will automatically go to clock mode.
• In time setting mode, press MODE button
to return to clock mode.
Thermometer
The unit is equipped with a built-in
thermometer. The current temperature is
updated every 30 seconds and is shown on the
display. In clock mode press SNOOZE button
to select Celsius or Fahrenheit thermometer
mode.
AUX input
To connect an external audio device (eg.
MP3-player), please use a standard stereo
cable with 3.5 mm to 3.5 mm plugs to connect
the audio line-out of the external device to the
AUX input socket of this unit.
Backlight
Hold the SET button for 2 seconds to
switch on the backlight, repeatedly press for 2
seconds to switch it off.
Power on/off
When the unit is connected to the current
supply mains, slide POWER switch to ON
position to switch the power on. To switch the
power off, slide POWER switch to OFF position.
Clock and calendar
• In clock mode (no ALARM indication)
press and hold SET button to enable time
setting mode. Press repeatedly SET button
to go to setting of parameters in following
sequence: minute => hour => 12/24-hour
4
4
Radio operation
• Radio reception is only available when the
unit is powered by the rechargeable battery.
• In clock mode press FUNCTION button to
choose the radio mode.
• For FM reception extend the telescopic
antenna.
• To adjust the frequency step by step
press repeatedly TUNE/ / /TUNE buttons.
For automatic search of a station, press and
hold TUNE/ / /TUNE buttons; the unit will
Instruction manual
look for the next available station and start
its broadcast. Repeat the operation to search
more stations.
• To save a station, press and hold MEM/
REP button. The memory position will blink.
Press MEM-UP/MEM-DN buttons to select a
memory position. Press MEM/REP button to
save the current station under the selected
number. You can store maximum 20 stations in
the memory.
• Hold the MEM/REP button for 2 seconds,
it will scan and save all the available stations
automatically.
During program saving, if no button is
pressed within several seconds, the unit will
return to normal radio mode.
• To call a saved station, press MEM-UP/
MEM-DN buttons.
• To adjust volume, in radio mode press
repeatedly VOL+/VOL- buttons.
• To switch off the radio, press POWER
button for 2 seconds.
USB/SD/MMC operation
Connecting USB/SD/MMC
• Insert a USB device into the USB port or
insert a memory card into the memory card
slot. Press FUNCTION button to enable USB/
SD/MMC mode. The unit will start reading the
device, LOAD will be displayed. Press and hold
button to select between USB or SD/MMC
mode, if both devices are inserted (USB is
played by default). If no device is detected, NO
CARD will be dislpayed.
• When the device and tracks on it are
detected, the display shows the total number of
tracks, currently playing track number, playback
time, equalizer mode and other playback
information. If no tracks are found in the
storage device, NO SONG will be displayed.
Playback operations
• During playback press button to pause
playback. Press this button again to resume
playback.
• During playback press TUNE/ / /
TUNE buttons to go to previous or next track.
• During playback press STOP button to go
to clock mode.
• To adjust volume, press repeatedly VOL+/
VOL- buttons.
• During playback press ALARM/EQ button
to select equalizer mode: Normal - Classic Bass - Live - Rock. The mode will be displayed
blinking. Press MEM/REP button to select
playback mode: All - Shuffle - Repeat One Repeat All. Press SET button to confirm.
During play mode selection, if no button
is pressed within several seconds, the unit will
return to normal playback mode.
• When all tracks are played or pause mode
is enabled, the unit will go to clock mode after
30 seconds if no buttons are pressed.
• In playback mode, press MODE button
switch off the player and go to clock mode.
If afterward you press button, the unit will
resume playing the last played track.
General USB/SD/MMC notes
• This unit is equipped with a USB socket
that can accept and play MP3 files stored on
standard USB flash (compatible with USB
version 2.0) up to 32 GB.
• This unit is also equipped with an SD/
MMC card socket that can accept and play
MP3 files stored on standard SD/MMC cards
up to 32 GB.
Always switch off the unit or change
mode to another one before removing a
USB flash drive or SD/MMC card, to prevent
damage to your USB device or memory card.
Note: Although this product is fully
compatible with USB 2.0 and SD/MMC card
standard formats, a small percentage of USB
flash drives and SD/MMC cards might not be
readable, due to those device manufacturers’
non-compliance with the full (official) USB and
SD/MMC card standards.
• FAT32 file system is supported by USB
and SD/MMC of this unit.
5
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.