Telefunken TF-1596 User Manual

RADIO WITH ALARM

РАДИОПРИЁМНИК С БУДИЛЬНИКОМ

TF-1596

Instruction manual

Руководство по эксплуатации

Instruction manual

Dear customer!

Thank you for purchasing our product. For safety, it is strongly recommended to read

this manual carefully before connecting, operating and/or adjusting the product and keep

the manual for reference in future.

Description

Buttons

Indicators

Time Display

Speaker

USB 5V adapter

socket

Antenna

Touch buttons

Battery

compartment

Stand assembly

Instruction manual

Important safeguards

•

The instruction manual contains important

operating and maintenance instructions. For

your safety, it is necessary to refer to the

manual. Keep the manual for future use.

•Do not hit or drop the unit

•

Do not expose the unit to vibration, direct

sunlight, too high or low temperatures or

humidity.

•Do not disassemble the unit yourselves

Refer servicing to qualified service personnel

All the illustrations in this manual are

schematic images, which may differ from

actual objects.

Power supply

Battery operation

•Insert 1 CR2032 battery (included)

to the terminals inside the battery

compartment according to the polarity marks

(+ and -). Your set will have a limited

operation from the battery supply, but there is

now the advantage that, in case of a mains

current failure or power outage, your clock will

continue to work. The clock display will not

light up, the clock time and alarm setting will

be held in the clock memory by the battery

back-up system.

This enables you to move the set from place

to place without re-setting the clock every time.

The battery back-up system is only meant to

be used for short-term power failures. For

longer durations the battery may become

exhausted or there may be some deviation in

accuracy.

• When the battery is exhausted, it

should be removed from the set to prevent

leakage. If you do not wish to take advantage

of the battery back-up system, your set will

work normally without batteries. However, if

disconnected from the mains, the clock

figures will flash when the mains are

reconnected and you must re-set the clock.

DС operation

•The appliance is for household use only.

•Before the first connecting of the appliance

check that the voltage indicated on the rating

label corresponds to the mains voltage in your

location.

•Plug the supplied AC/DC power

adaptor into the DC

unit.

the

household main outlet. Make sure the voltage

is compatible.

•Always remember to disconnect

the power cord from the main supply before

disconnecting it from the unit.

Connect

adaptor input

the

power cord to the AC

the back

General operations

Placement

•Place the device close to you,

approximately 40-50 cm from your head, for

example, on a bedside table.

Setting time

•You have to set the clock time when you

plug in the appliance for the first time and when

there has been a power failure.

•When the time starts to blink touch

to adjust it. Touch to confirm. Setting

will be canceled if no button is pressed in

10 seconds.

•Change current time by pressing and

holding for 3 seconds until the time starts

to blink. Touch to adjust it. Touch to

confirm. Setting will be canceled if no button is

pressed in 10 seconds.

•Choose between a 12-hour

modes by pressing . When the 12-hour

format is selected, AM or PM will be displayed.

•Press to adjust the brightness of

time display: Low - High - Off.

•When low brightness is selected, it will

automatically change to high brightness

when you change any settings, and then

revert back to low intensity after 5 seconds.

and 24-hour

Light

•Press once to switch on white

light and use it as a bedside lamp. You can

adjust the light intensity by touching,

there are 10 levels in total.

Instruction Manual

• Press again to enter into an

automatic color changing mode and use it as

a mood light. Touch to select color

from green, red, blue, purple, orange or

indigo.

•Touch for a third time to switch

the light off.

Setting the alarm

• Press to switch the alarm on or

off. The alarm symbol appears on the

display when you switch on the alarm, and

disappears when you switch it off.

• Press and hold to set the alarm,

the time indication will start to blink and

you can adjust the alarm time by

pressing . Press to confirm the

alarm time. Setting will be canceled if no

button is pressed within 5 seconds.

• Press , then press to choose

between 1 and 7 as a wake-up sound

(1-6 are pre-set nature sounds, 7 is FM

radio). If you choose from 1 to 6 as the

alarm sound, a sample of that sound will

play for 60 seconds, if you choose 7, your

last listened FM radio station will be set

as the alarm signal. Press to confirm.

Setting will be canceled if no button is

pressed within 60 seconds.

•You can choose the wake-up sound

volume level between 00 and 15 (the

up to 15, default is 3) by pressing

then back from 15 to 00.

Sunrise simulation wake-up light

30 minutes before the alarm time, the

sunrise simulation white light will be on

from 1% to 100% intensity at alarm time to

prepare our body for waking up and

getting alert.

When the alarm time comes, the wake-

up sound will play for 5 minutes.

During this time you can touch to

enter the snooze mode, the wake-up

sound will play again after 5 minutes and

last for 5 minutes. Touch or press any

button except to stop the sound and

wake-up light. During the wake-up light

period, you can switch off the wake-up

light by touching and holding .

•If the radio is playing when the

alarm time comes, the default alarm sound will

play and the radio will stop. The radio will

resume after the alarm sound is stopped.

Sunset simulation and sleep time

• Press to switch the sunset simulation.

"15" will be displayed. Press repeatedly to

select 15 /30 / 60 / OFF. The numbers

represent the time in minutes that the light will

take to dim. When the desired number is

displayed, don't press any buttons for 5

seconds. This will set the sunset time.

• During sunset simulation the button

will flash. Press it to cancel the simulation and

keep the current brightness. Press and hold

the button to switch off the light.

•If the radio is playing during the sunset

simulation, it will switch off together with the

light.

Radio

•Press the FM button to turn the

radio on and off.

•In FM radio mode touch and hold FM

to automatically scan and save available radio

stations. Touchto switch between stations.

•Adjust the volume from 00 to 15 by

pressing .

•To get a good radio signal, fully

unwind the antenna and move it around until you get

the best reception.

Instruction manual

Maintenance and care

Switch off the unit, unplug from the power

supply. The outside of the appliance can be

cleaned with a slightly damp cloth.

Specifications

AC/DC adaptor

Nominal power consumption5 W

Clock3 V (1 x 3V CR2032 battery)

Display0.8" (2 cm) LED

Radio frequencyFM: 87.5 - 108 MHz

Unit dimensions

Net weight

Specifications and functions are subject to change without notice. It is connected with continual

improvement of the device.

MANUFACTURED AND DISTRIBUTED BY TECHNO ELECTRIC LIMITED,

Legal address: 801 Luk Yu Building, 24 - 26 Stanley Street, Central, China

TELEFUNKEN and the TELEFUNKEN logo are trademarks of TELEFUNKEN Licenses

GmbH and are used under a trademark license.

Accessories

Alarm clock

AC/DC Adaptor

USB cable

CR2032 battery

Instruction manual

Input: ~ 100-240 V; 50/60 Hz

Output: 5 V, 1.5 A

170 x 83 x 183 mm

~ 0.425 kg

1 pc

+ 11 hidden pages