Telefunken TF-1595U User Manual [ru]
RADIO WITH ALARM
РАДИОПРИЁМНИК С БУДИЛЬНИКОМ
TF-1595U
Instruction manual
Руководство по эксплуатации
Instruction manual
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.
Description
1. Clock set/Memory button
2. Dimmer set button/Mono/ST
switch
3. Hour set button/Skip-
4. Minute set/Skip+
CLOCK
DIM
Mono / St.
HOUR MIN. AL.1 AL.2
MEM.
SNOOZE/SLEEP
1 2 3 4 5 6 7 8 9
FUNC.
Auto-Scan
AL. OFF
5. Snooze Sleep
6. Alarm 1 set/Volume down button
7. Alarm 2 set/Volume up button
15
8. Function Switch/Auto-scan
9. Alarm OFF/ Power button
10. LED display
11. DC 5V jack
12. USB charging port
13. AUX IN JACK
14. FM Antenna
15. QI (wireless charging) position
10
DC5V AUX INUSB CHARGING
11 12 13 14
Not indicated: speakers (sides), battery compartment (bottom).
2
Instruction manual
Important safeguards
•
The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer to the
manual. Keep the manual for future use.
• Do not hit or drop the unit
•
Do not expose the unit to vibration, direct
sunlight, too high or low temperatures or
humidity.
• Do not disassemble the unit yourselves
Refer servicing to qualified service personnel
All the illustrations in this manual are
schematic images, which may differ from
actual objects.
check that the voltage indicated on the rating
label corresponds to the mains voltage in your
location.
• Plug the supplied AC/DC power
adaptor into the DC adaptor input on
of the unit. Connect the power cord to the AC
household main outlet. Make sure the voltage
is compatible.
• Always remember to disconnect
the power cord from the main supply before
disconnecting it from the unit.
the back
General operations
Power supply
Battery operation
• Insert 2 ААA batteries (not included)
to the terminals inside the battery
compartment according to the polarity marks
(+ and -). Your set will not work normally from
the battery supply, but there is now the
advantage that, in case of a mains current
failure or power outage, your clock will
continue to work. The clock display will not
light up, the clock time and alarm setting will
be held in the clock memory by the battery
back-up system.
This enables you to move the set from place
to place without re-setting the clock every time.
The battery back-up system is only meant to
be used for short-term power failures. For
longer durations the batteries may become
exhausted or there may be some deviation in
accuracy.
• When the batteries are exhausted, they
should be removed from the set to prevent
leakage. If you do not wish to take advantage
of the battery back-up system, your set will
work normally without batteries. However, if
disconnected from the mains, the clock
figures will flash when the mains are
reconnected and you must re-set the clock.
Backlight brightness
• Press the DIM button to select between
the levels of display backlight brightness (low,
middle, high). The default is high.
Setting the time and date
• Press and hold the CLOCK/MEM. button.
The time will start to flash.
• Press the HOUR/SKIP- button
to increase the HOUR. You can press and hold
the button to increase the number quickly.
• Press the MIN/SKIP+ button
to increase the MINUTES. You can press and hold
the button to increase the number quickly.
• Once time is set correctly, press the
CLOCK/MEM. button again to confirm.
• Next set the date. Press the SKIP+/SKIP-
buttons to select the year. Press CLOCK/MEM.
to confirm.
• Press the SKIP+/SKIPand day. Press CLOCK/MEM. to confirm.
• The time and date are now set.
The unit will automatically exit the setting mode
if no buttons are pressed for 5 seconds.
to select the month
DС operation
• The appliance is for household use only.
• Before the first connecting of the appliance
3
Setting the alarm
• When the unit is in standby mode
(radio is off), press and hold the AL.1/ VOLbutton, the “AL.1-BUZZ” indicator and time
will start blinking, the default alarm time is
08:00.
• Press the HOUR/SKIP- button
to set the alarm hour, press the MIN/SKIP+
button to set the alarm minute, press AL.1/
VOL- button to confirm the setting.
• Press the HOUR/SKIP- button
and MIN / SKIP+ button to select the days
of alarm activation:
• “WEEK 1-7” means that the alarm will
go off on every day of the week.
• “WEEK 1-5” means that the alarm will
go off only on weekdays (Monday Friday).
• “WEEK 6-7” means that the alarm will
go off only on weekend (Saturday
and Sunday).
Press AL.1/VOL- button confirm the date.
• Press the HOUR/SKIP- button
and MIN / SKIP+ button to select the alarm
volume level (0-16). Th default volume is
10. Press AL.1/VOL- button confirm the
volume.
You can adjust the alarm volume
only when radio is selected as the alarm
volume. The volume will gradually increase
from 0 to the set volume.
• When the unit is in standby mode
(radio is off), press the AL.1/ VOL- button to
select the alarm source: BUZZER - RADIO ALM OFF. If no button is pressed for 5
seconds the unit will confirm the alarm and
exit the setting mode.
• In standby mode press and hold the
AL.2/VOL+ button to set the 2nd alarm.
Follow the same steps as described above.
Snooze control
• When the alarm time comes,
the signal will sound for 60 minutes if no
button is pressed. After that the alarm will
stop and start at the same time the following
day.
Instruction Manual
• When the alarm is on, press the
SNOOZE/SLEEP button to interrupt the
alarm signal. After 9 minutes the alarm will
start again.
• If you want to stop the alarm, press
AL.OFF/POWER button. The alarm will
resume in 24 hours.
Radio
• Press the AL.OFF/POWER button
to turn the unit on. The radio mode is
activated by default.
• To automatically scan and store
available radio stations, press the FUNC.
button.
• Press and hold the HOUR/SKIPor MIN/SKIP+ button to automatically
search for the previous or next radio
station with strong signal.
• Short press the HOUR/SKIPor MIN/SKIP+ button to manually adjust the
radio frequency.
• Press the VOL-/VOL+ buttons
to adjust the volume level.
Storing and recalling radio stations
• If you want to store a radio station
in memory, first select the station you want to
store, next press and hold the CLOCK/MEM.
button. "P01" will start blinking, meaning that
the station will be stored as Preset 1.
• Press the HOUR/SKIP-
or MIN/SKIP+ button to select a different
memory preset. Press the CLOCK/MEM.
button again to confirm.
• To recall a saved preset station
press the CLOCK/MEM. button. "P01" will
appear on the screen. Press this button again
to select other presets. The display will show
a station frequency 5 seconds later, and will
exit show the time if no button is pressed for 5
seconds.
4
Instruction manual
Auto power off (Sleep function)
• Power on the unit, press the
SNOOZE/SLEEP button to turn on the sleep
mode. The default sleep time will appear on the
display. Press this button repeatedly to select
the sleep time period (10-90 minutes) or to
switch it off. The radio will turn off automatically
after the sleep time period elapses. You can
turn this function of by pressing and holding the
SNOOZE/SLEEP button.
AUX
You can connect the audio output of an
external device to this unit, to listen to the sound
of that device through the speakers of this unit.
• To connec
please use a standard audio cable with 3.5mm-to-3.5 mm plugs (not included) to connect
th
e headphone out or audio line-out of the
external device to the AUX input socket.
• Selec
button.
• Turn on the external device. You cannot
control playback with the buttons of this unit
except adjusting the volume.
t an external audio device,
t the AUX mode usin
g the FUNC.
Specifications
USB charging
• The USB port is used to charge the
battery of any supported (DC 5V 1A)
external device from this unit.
• You cannot play music from devices
connected to the USB port.
Qi wireless charging
• The top panel of the unit is
a Qi wireless charging panel. If your mobile
device supports the Qi charging feature,
you can place it on the panel to charge it.
• The Qi indicator on the unit will light
up when wireless charging is in proccess.
Maintenance and care
Switch off the unit, unplug from the power
supply. The outside of the appliance can be
cleaned with a slightly damp cloth.
Accessories
Radio
DC adaptor
Instruction manual
1 pc
1 pc
1 pc
Nominal voltage
Power supply ~220 V, 50 Hz
Nominal power consumption 5 W
USB port 5 V, 1 A
Radio frequency FM: 87.5 - 108 MHz
Unit dimensions
Net weight
Specifications and functions are subject to change without notice. It is connected with continual
improvement of the device.
MANUFACTURED AND DISTRIBUTED BY TECHNO ELECTRIC LIMITED,
Legal address: 801 Luk Yu Building, 24 - 26 Stanley Street, Central, China
TELEFUNKEN and the TELEFUNKEN logo are trademarks of TELEFUNKEN Licenses
GmbH and are used under a trademark license.
5
Radio: DC adaptor 5 V, 2A
Clock: 3 V (1.5 V x 2 AAA batteries)
163 x 154 x 78 mm
0.527 kg
Loading...