R E S I D E N T I A L
PREMIER® POWER DIRECT VENT
96% THERMAL EFFICIENCY POWER DIRECT VENT
The 100,00 BTU Premier® Power Direct Vent residential gas water heater is equipped with a fully submerged, spiral-shaped condensing heat exchanger. This design provides a much greater heat transfer surface than a standard straight flue tube, resulting in 96% thermal efficiency and higher hot water output* than comparable 80% efficient water heaters.
GP6 50 YTPDT & GP6 75 YTPDT
Model Shown
GP6 50 YTPDT
Series 130/131
ENERGY STAR® Qualified
Helical Internal Heat
Exchanger
•Spiral heat exchanger keeps hot combustion gases in the tank longer lengthen the heat transfer cycle
•Positioned in the center of the tank for more even heat distribution
•Operates at 96% thermal efficiency, which saves money on operating costs compared to a standard 80% efficient gas water heater
Power Direct Vent Design
•Uses inexpensive PVC, CPVC, ABS or polypropylene pipe for intake and exhaust
•Can be vented vertically thru-the-roof or horizontally thru-the-wall
•2” pipe, vents up to 45 equivalent feet
•3” pipe, vents up to 128 equivalent feet
•Optional concentric vent kit available
Condensing Design
•96% efficient condensing design
•Equipped with condensate drain tee
Side-Mounted Hot and Cold
Recirculating Taps
•Allows the Premier® Power Direct Vent to be installed as part of combination space heating/water heating applications
Advanced Electronic Control
•Large LCD display
•Precise temperature control
•Advanced diagnostics
•iCOMM™ Compatible and can be monitored from remote
locations. Call 1.888.WATER02 for more information.
Available in Natural Gas or Propane
Heavy-Duty Anodic Protection
•Provides even more protection against corrosion
Commercial Grade
Glass Lining
•Provides superior protection against corrosion
•Protects all interior tank surfaces including inside and outside of the helical heat exchanger
Top-Fired Ultra-Low NOx
Gas Burner
•Enhanced Ultra-low NOx burner complies with SCAQMD Rule 1121 and other Air Quality Management Districts with similar requirements for NOx emissions of less than 10 ng/j
CSA Certified and ASME
Rated T&P Relief Valve
Maximum Hydrostatic Working Pressure: 150 psi
Codes and Standards
•Design-certified by CSA International according to ANSI Z21.10.3-CSA 4.3 standards
•These models meet the thermal efficiency and standby loss requirements of the U.S. Department of Energy and current edition of ASHRAE/IESNA 90.1
Six-Year Limited Parts And
Tank Warranty
•For complete information, consult written warranty or contact your local sales rep.
Model GP6 50 YTPDT *4.31 GPM continuous flow, based on 65°F inlet water temperature, 110°F outlet temperature.
For more information on the Premier® Power Direct Vent, contact:
State Water Heaters
500 Tennessee Waltz Parkway Ashland City, TN 37015
800-365-0024 Toll-free USA www.statewaterheaters.com
SRGSS02513