Spectra Precision ProMark 700 User Manual
ProMark™ 700
User Guide
Legal Notices
©2013 Trimble Navigation Limited. All rights
reserved.
All product and brand names mentioned in this publication are trademarks of their respective holders.
Limited Warranty Terms and Conditions
Product Limited Warranty. Subject to the terms and
conditions set forth herein, Trimble Navigation Limited (“Trimble”) warrants that for a period of (1) year
from date of purchase this Spectra Precision product
(the “Product”) will substantially conform to our
publicly available specifications for the Product and
that the hardware and any storage media components of the Product will be substantially free from
defects in materials and workmanship.
roduct Software. Product software, whether built
P
into hardware circuitry as firmware, provided as a
standalone computer software product, embedded in
flash memory, or stored on magnetic or other media,
is licensed solely for use with or as an integral part of
the Product and is not sold. The terms of the end
user license agreement govern the use of the
Software, including any differing limited
Product
warranty terms, exclusions and limitations, which
shall control over the terms and conditions set forth
in the limited Product warranty.
Warranty Remedies. If the Product fails during the
warranty period for reasons covered by this limited
warranty and you notify us of such failure during the
warranty period, we will repair OR replace the nonconforming Product with new, equivalent to new, or
reconditioned parts or Product, OR refund the Product purchase price paid by you, at our option, upon
your return of the Product in accordance with our
product return procedures then in effect.
Notices
Class B Statement - Notice to Users. This equipment
has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio
communication. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved by
the manufacturer or registrant of this equipment can
void your authority to operate this equipment under
Federal Communications Commission rules.
Canada
The digital apparatus does not exceed the Class B
limits for radio noise emissions from digital apparatus as set out in the radio interference regulations of
the Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits
radioélectriques dépassant les limites applicables
aux appareils numériques de Classe B prescrites
dans le règlement sur le brouillage radioélectrique
édicté par le Ministère des Communications du
Canada.
Europe
This product has been tested and found to comply
with the requirements for a Class B device pursuant
to European Council Directive 89/336/EEC on EMC,
thereby satisfying the requirements for CE Marking
and sales within the European Economic Area (EEA).
These requirements are designed to provide reasonable protection against harmful interference when
the equipment is operated in a residential or commercial environment.
Notice to Our European Union Customers
For product recycling instructions and more information, please go to http://www.spectraprecision.com/
footer/weee-and-rohs/.
Recycling in Europe: To recycle Spectra Precision
WEEE (Waste Electrical and Electronic Equipment
products that run on electric power), call +31 497
53 24 30 and ask for the “WEEE Associate”. Or, mail
a request for recycling instructions to:
Tri m b l e Eu r o p e BV
c/o Menlo Worldwide Logistics
Meerheide 45
5521 DZ Eersel, NL
declare under sole responsibility that the product:
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
(2) and this device must accept any interference
CAUTION: This product contains two rechargeable
Li-ion batteries with a capacity of 2.5 Ah each.
Please refer to the regulations in force in your country
concerning the use and transportation of Li-ion batteries. These regulations shall apply to the entire receiver as the batteries are non-removable by the end
user. Battery replacement can only be performed by
Regional Service Centers (RSC) or Authorized Service Provider personnel (ASP).
Declaration of Conformity
We, Spectra Precision,
ProMark 700 GNSS receiver
complies with Part 15 of FCC Rules.
received, including interference that may cause
undesired operation.
Table of Contents
Welcome to Spectra Precision ProMark 700 ........................................1
ProMark 700 Packout .........................................................................2
Standard Accessories.............................................................2
Optional Accessories..............................................................2
Using ProMark 700 for the First Time...................................................3
Discover Your New Equipment ................................................3
Charging the Batteries............................................................3
Getting Started......................................................................4
Reading the Battery Status.....................................................4
Battery Charging Modes ......................................................................5
Appendix ............................................................................................7
Main Technical Specifications ................................................7
Product Storage.....................................................................9
Power/Data Connector Pinout..................................................9
Reset Procedure ....................................................................9
Auto-Test at Start-up ...........................................................10
Installing a Firmware Upgrade ..............................................10
Memo.................................................................................12
Welcome to Spectra Precision ProMark 700
Congratulations on your decision to purchase a Spectra
Precision ProMark 700.
ProMark 700 is a GPS/GLONASS/SBAS L1/L2 receiver
specifically designed to be used as a network RTK rover.
ProMark 700 is very simple to use:
• Easy battery handling: ProMark 700 uses built-in,
rechargeable, non-removable batteries.
• Cable-free: The data collector and the ProMark 700
communicate over a wireless connection.
• GNSS-dedicated: ProMark 700 is focused on offering the
best GNSS performance. The data collector’s cellular
modem is used to connect to the RTK network, receive
RTK corrections and route them to the ProMark 700
receiver.
English
1
ProMark 700 Packout
[1]
[2]
[3]
[4]
[5]
English
Standard
Accessories
Optional
Accessories
The ProMark 700 packout consists of the following items:
• [1]: ProMark 700 GNSS receiver
• [2]: Universal AC/DC adapter shipped with four different
types of input connectors.
• [3]: Power cable extension (male jack to 6-pin connector)
• [4]: Vehicle power cable (cigarette lighter connector type
to female jack)
• [5]: Soft transport bag.
Cable Kit P/N 91865-00 (see picture).
This kit is used to establish a USB connection between the
ProMark 700 and a computer. This connection is required for
upgrading the GNSS firmware when the computer has no
Bluetooth.
Because the process takes 15-20 minutes, the ProMark 700
should always be connected to external power when updating
firmware.
The optional cable kit therefore consists of:
• A V-shaped cable terminated with a DB9-f connector. One
of its other ends is fitted with a female jack, for
connection to a power source, and the other with a 6-pin
circular connector for connection to the ProMark 700.
• A short cable extension (USB to DB9-m), to be used
between the computer (USB port) and the V-shaped cable
(SubD-9m).
2
Loading...