Sonova USA TX7 User Manual
This unit sold by:
www.phonak.com
029-0431-02/V00 0505/A+W Printed in Switzerland © Phonak AG All rights reserved
EasyLink
™
User Guide
0682
!
Contents
Controls 4
Welcome 6
EasyLink and accessories 7
Starting up 8
Using EasyLink 14
FM receivers 22
Important points 24
For professionals: Changing the radio channel 25
Troubleshooting 26
Declaration of conformity 30
Service and warranty 31
Phonak distributors worldwide 32
4
Controls
햲
햳
햴
햵
햶
햷
햸
햹
5
햲 On/off switch
햳 Microphone openings
햴 Lavalier with integrated antenna
햵 Button to adjust the lavalier length
햶 Clip
햷 LCD
햸 For professionals:
Pen push for frequency change
햹 Interface for external connections
6
Welcome
The new EasyLink FM transmitter is very easy to
operate and delivers high sound quality. One push of
the button and the finely tuned internal microphone
in EasyLink picks up sound at the source and delivers
it directly to the iLinks or to any other Phonak FM
receivers at your ears.
To obtain maximum benefit from EasyLink, please
read this user guide carefully. Ask your hearingcare
professional if you have any questions.
Phonak wishes you much hearing enjoyment with
EasyLink.
The following symbols appear
in this user guide:
Important notes for all users.
Special notes for users of digital Phonak hearing
instruments with remote control compatibility
(Savia, Perseo, Claro, Supero and all future
remote-controllable Phonak hearing instruments.)
!
7
EasyLink and accessories
햲 EasyLink
햳 Easylink home and travel case
햴 Adapter for external connections
햵 Audio cable
햶 Charging unit
햷 iLink or any MicroLink radio receiver*
*
The type of the Phonak FM receiver depends
on the hearing instrument. In the picture: MLxS
8
Starting up
Charging EasyLink
EasyLink contains a non-removable Lithium-ion battery
with fast–charge capability. A fully discharged battery
takes around 2 hours to recharge. The battery will be
about 80% charged within an hour.
Plug the charging unit
into the power socket.
Attach the
EasyLink adapter
click
햲
햳
9
Plug the charging unit into
the power jack on the
adapter marked
Use only original Phonak charging units
• The battery symbol in the EasyLink display
flashes during charging. The battery cannot
be over-charged.
• The battery symbol stops flashing when the
EasyLink is 100% charged.
• EasyLink operates for approximately 10 hours
when fully charged.
• For pluggable equipment, the socket-outlet
shall be installed near the equipment and easily
accessible.
DC 7.5V
!
DC 7.5V
햴
10
Switching on/off
To switch on:
Press and hold the
button for two seconds.
To switch off:
Press and hold the button
again for two seconds.
The display shows startup information during
switch-on. When the EasyLink is ready, the following
information appears:
• FM channel number
• Battery status
Loading...