SHC 4376 PERSONAL TRIMMER
INSTRUCTION MANUAL
EN
RU
1
2
3
4
- 1 -
ENGLISH
SHC 4375 PERSONAL TRIMMER
INSTRUCTION MANUAL
The hair repairer solves your care problems about beard and hair, it contains innovative
razors even in the most sensitive areas, allowing you to enjoy comfortable shaving and
shaving feeling at any time.
This product has anti-sensitivity functions, which is not designed for facing shaving and
shaving!
1. Keep the product dry!
2. This product supports flushing under the faucet, but do not immerse it into the water!
3. Minors and persons with physical or mental disorders shall use this product under
the supervision of a guardian.
4. If the product is damaged, stop using it immediately.
5. If the product is not used for more than one month, Please remove the battery.
PARTS DESCRIPTION
1. Blades, 2. On/Off Button, 3. Body, 4. Battery Cover
1*AA Battery
Cleaning Brush
FEATURES
Power supply voltage: DC 1.5V 3W
Battery: Use with 1AA batteries (Not included)
READY TO USE
1. Before using this product, unscrew the rear battery cover to the left as shown in Figure
2. Insert the positive battery into the battery compartment as shown in Figure 2.
3. Turn the rear battery cover to the right as shown in Figure 3.
Fig.1 Fig.2 Fig.3
- 2 -
USAGE
Shaving Steps:
1. Use scissors to shave against the direction of hair growth (see Fig. 1.2.3) to achieve
a better shaving effect. If you need to keep the shape, install the 1, 2, 4 and 6 mm shear
attached to the scissors according to your needs.
2. Hold the handle at an angle of 45 degrees so that the knife is perpendicular to the
skin. Tighten your skin by hand to lift hair so as to help it more easily enter the knife net
and shave in the way of back and forth.
Pruning Steps
1. Use scissors to shave against the direction of hair growth (see Fig. ) to achieve a better
shaving effect. If you need to keep the shape, install the 1, 2, 4 and 6 mm shear attached
to the scissors according to your needs.
2. Hold the handle at an angle of 45 degrees so that the knife is parallel to the skin and
shave in the way of one direction.
NOTICE
1. To avoid damaging the tool bit assembly, do not press it too hard against the skin.
2. It is recommended that you should continuously use the new razor for 2 to 3 weeks
to adapt to the new razor system.
CLEANING AND MAINTENANCE
To achieve the best shaving effect, clean the product after each use.
1. Turn on the razor and rinse directly under the faucet.
2. Shake off the water and dry the razor.
- 3 -
- 6 -
04-2019
- 7 -
Loading...