Sharp FP-H50A Operation Manual

Download

ENGLISH

中文

FP-H50A

AIR PURIFIER OPERATION MANUAL

空氣清新機使用說明書

Free standing type

直立型號

“Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation.

*The number in this technology mark indicates an

approximate number of ions supplied into air of 1 cm

which is measured around the center of a room with

the “high-density plasmacluster 7000” applicable oor area (at 1.2 m height above the oor) when the device

is placed close to a wall at the MED mode setting.

OM_FP-H50A.indd 1 2017/04/05 10:01:08

NOTE

The air purier draws in room air from the air intake, passes the air through a Pre-

Filter, a Active Carbon Deodorizing Filter and a HEPA Filter inside of the unit, then discharges the air through the air outlet. The HEPA Filter can remove 99.97% of dust

particles as small as 0.3 microns that pass through the lter.

The Active Carbon Deodorizing Filter gradually absorbs odors as they pass through

the lter.

Some odors absorbed by the lters may break down over time, resulting in additional

odor. Depending on the usage environment, especially when the product is used in

extreme environments (significantly more severe than normal household use), this

odor may become strong in a shorter period than expected. If the odor persists, the

lters should be replaced.

• The air purier is designed to remove air-suspended dust and odor, but not harmful gases (for example, carbon monoxide contained in cigarette smoke).

Please read before operating your new Air Purier

HEPA Filter

Active Carbon Deodorizing Filter

Back Panel (Pre-Filter)

OM_FP-H50A.indd 2 2017/04/05 10:01:09

ENGLISH

E-1

ENGLISH

Thank you for purchasing the SHARP

Air Purier. Please read this manual carefully.

Before using this product, be sure to read the section: “Important Safety Instructions.” After reading this manual, keep it in a convenient location for future reference. For your reference, we recommend to keep this manual in the place where you can read at any time.

IMPORTANT SAFETY INSTRUCTIONS

.....

E-2

PARTS NAME

...............................................

E-4

FILTER INSTALLATION

.............................

E-5

OPERATION

.................................................

E-6

CARE AND MAINTENANCE

.....................

E-8

TROUBLESHOOTING

..............................

E-10

SPECIFICATIONS

......................................

E-11

CONTENTS

FEATURES

Unique Combination of Air Treatment Technologies Triple Filtration System + Plasmacluster Ions

TRAPS DUST*

Pre-lter traps dust and other large

airborne particles.

REDUCES ODORS

Active Carbon Deodorizing lter absorbs

many common household odors.

REDUCES POLLEN & MOLD*

HEPA lter traps 99.97% of particles as

small as 0.3 microns.

FRESHENS

Plasmacluster treats the air similar to the way nature cleans the environment by emitting a balance of positive and negative ions.

*When air is drawn through the lter

system.

Sensor Technology continuously monitors air quality, and automatically adjusting

airow based on detected air purity.

OM_FP-H50A.indd 1 2017/04/05 10:01:10

E-2

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, basic safety precautions should be followed, including the following:

WARNING

- To reduce the risk of electric shock, re or injury to persons:

• Read all instructions before using the unit.

• Use only a 220 volt outlet.

• Do not use the unit if the power cord or plug is damaged or the connection to the wall outlet is loosened.

• Periodically remove dust from the power plug.

• Do not insert ngers or foreign objects into the intake or air outlet.

• When removing the power plug, always hold the plug and never pull the cord.

Electric shock and/or re from short circuit may occur as a result.

• Be careful not to damage the power cord, it may cause electric shock, excess heat or

res.

• Do not remove the plug when your hands are wet.

• Do not use this unit near gas appliances or replaces.

• Remove the power plug from the wall outlet before cleaning the unit and when not using the unit.

Electric shock from bad insulation and/or re from short circuit may occur as a result.

• When cleaning the unit, or when the unit is not in use, be sure to unplug the unit. Electric

shock and/or re from a short circuit may result.

• If the power cord is damaged, it must be replaced by the manufacturer, its service agent, Sharp Authorized Service Centre or similarly qualified person in order to avoid a hazard.

• Do not operate when using aerosol insecticides or in rooms where there is oily residue,

incense, sparks from lit cigarettes, chemical fumes in the air or in very high humidity conditions, such as a bathroom.

• Be cautious when cleaning the unit. Corrosive cleansers may damage the exterior.

• Only a Sharp Authorized Service Centre should service this air purifier. Contact the

nearest Service Centre for any problems, adjustments, or repairs.

• This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

NOTE

- Radio or TV Interference

If this air purier should cause interference to radio or television reception, try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the unit and radio/TV receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

OM_FP-H50A.indd 2 2017/04/05 10:01:10

ENGLISH

E-3

CAUTIONS CONCERNING OPERATION

• Do not block the air intake and/or air outlet.

• Do not use the unit near or on hot objects, such as stoves or heaters or where it may come into contact with steam.

• Do not lay the unit down when using.

• Always hold the handle on the back of the unit when moving it.

• Do not use without the lters installed inside the unit.

• Do not wash and reuse the HEPA lter and the Active Carbon Deodorizing lter.

Not only does it not improve lter performance, it may cause electric shock or malfunction.

INSTALLATION GUIDELINES

• When using the unit, place it away from equipment utilizing electric waves such as

televisions or radios to avoid electrical interference.

• Avoid using in locations where furniture, fabrics or other items may come in

contact with and restrict the air intake and/or air outlet.

• Avoid using in locations where the unit is exposed to condensation or drastic

temperature changes. Appropriate condition is at room temperature 0 – 35 ºC.

• Place on a stable surface with sufcient air circulation. When placing the unit on a heavily carpeted area, the unit may vibrate slightly.

• Avoid locations where grease or oily smoke is generated.

The unit surface may crack as a result.

• Place the unit about 30 cm(1 ft) away from the wall in order to ensure proper

airow.

The dust collecting performance will be the same even if using the unit 3cm away from

the wall, but place it as far as possible(30cm away recommended) because it may dirty the wall or oor around.

FILTER GUIDELINES

• Follow the instructions in this manual for correct care and maintenance of the lter.

OM_FP-H50A.indd 3 2017/04/05 10:01:10

E-4

PARTS NAME

Main Unit

Handle

Air Outlet

Dust sensor/ Dust Sensor Filter

OFF TIMER Button / OFF TIMER indicator Light (green) LIGHT ON/OFF Button (Press 3 sec.)

HEPA Filter

MODE Button / MODE Indicator Light (green) Plasmacluster Ion ON/OFF Button(Press 3 sec.)

Active Carbon Deodorizing Filter

CLEAN ION SHOWER Button / CLEAN ION SHOWER indicator Light (green)

Upper Tabs

Back Panel (Pre-Filter)

POWER ON/OFF Button

Bottom Tabs

ODOR Sensor

Power Cord

DUST AND ODOR SIGN

Plug

PLASMACLUSTER SIGN

Date Label

BACK

FRONT

PLASMACLUSTER SIGN blue Plasmacluster ON off Plasmacluster OFF

Clean

Impure

Red

Orange

Green

3 4 5 6

DUST AND ODOR SIGN Indicates the air purity of the room in 3 levels with color changes.

OM_FP-H50A.indd 4 2017/04/05 10:01:14

ENGLISH

E-5

FILTER INSTALLATION

To maintain the quality of the lter, it is installed in the main unit and packed in plastic bag. Be sure to remove the lter from the plastic bag before using the unit.

Remove the Back Panel.

Remove the plastic bag and

take out the Filter.

Place the Filter inside the main

unit.

Do not install the lter backwards or the

unit will not operate properly.

Upper Tabs

• Do not operate the unit without the lter.

Date Label

Pull

Push

Be sure to remove the power plug from the wall outlet.

Starting Date Of Filters

. .. .

HEPA過濾網＆活性碳除臭過濾網

MODEL

FZ-F45SFA

HEPA Filter & Active Carbon Deodorizing Filter

約10年

~10 years

Replace the Back Panel to the

main unit.

Fill in the usage start date on the

Date Label.

Use the date as a guide for the lter

replacement schedule.

Bottom Tabs

HEPA Filter

Active Carbon Deodorizing Filter

OM_FP-H50A.indd 5 2017/04/05 10:01:20

E-6

OPERATION

AUTO SLEEP MED MAX

CLEAN AIR

START

• Select the desired fan speed.

• Unless the power cord has been unplugged, the operation starts in the previous mode it was operated in.

STOP

FAN SPEED

SLEEP

• The unit will operate very quietly, and the fan speed is automatically switched depending on the amount of impurities in the air. DUST AND ODOR /PLASMACLUSTER SIGN go off automatically. Even though the indicator is off, Plasmacluster Ion is released into air unless Plasmacluster Ion is turned off by

NOTE

AUTO

• The fan speed is automatically switched depending on the amount of impurities in the air. The sensors detect impurities

for efcient air purcation.

Releases high-density Plasmacluster ions and discharges strong air ow for 60 minutes.

CLEAN ION SHOWER

START

• If Plasmacluster Ion is OFF, Plasmacluster Ion will not be released.

• When the operation nishes, the unit will return to the prior

operation mode.

It is able to change the other mode or turn off during this

mode.

NOTE

OM_FP-H50A.indd 6 2017/04/05 10:01:37

ENGLISH

E-7

Light Control

Plasmacluster Ion ON/OFF

You can turn OFF the DUST AND ODOR /PLASMACLUSTER SIGN when they are lighting up.

● 2h ● 4h ● 8h CANCEL

more than 3 sec.

OFF

• When the unit restarts its operation, Light Control resumes its setting set before turning off.

• At Sleep Mode, Light Control is available.

NOTE

When Plasmacluster Ion is ON, the PLASMACLUSTER SIGN will turn on. (blue) (In operation)

ON OFF

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

Set to “Low” if the DUST AND ODOR SIGN is constantly red to reduce sensitivity, and set to “High” if the DUST AND ODOR SIGN is constantly green to increase sensitivity.

OFF TIMER

Select the time turning off the unit during operation. The unit automatically stops once the selected time is reached.

• If the Power ON/OFF Button is not pressed within 8 seconds of adjusting sensor sensitivity, the setting will be saved automatically.

• The sensor sensitivity setting will be saved even if the unit is unplugged.

NOTE

(with the unit OFF)

High

Standard

Low

more than 3 sec.

more than 3 sec. more than 3 sec.

more than 3 sec.

Select the sensor detection sensitivity.

OM_FP-H50A.indd 7 2017/04/05 10:01:47

+ 19 hidden pages

Sharp FP-H50A Operation Manual

Specifications and Main Features

Frequently Asked Questions

User Manual