RADIO CONTROLL TXX 4
4 channel transmitter with the capability for 12 and 18 bit
code transmission and the division of codes for common
and personalised command management.
- Mod. TXQ 4 *: 30,875
MHz
- Mod. TX 4 *: 306 MHz
- Mod. TX 4/330 *: 330 MHz
- Mod. TXS 4: 433,92 MHz
* This product is destined only for countries in which its use
is allowed
Technical Data
- Battery power supply: 12VDC (23A)
- Working Frequency: See Model
- Possible code combinations: 262144
- Max. consumption: 25mA
- Working Temperature: -20÷70°C
- Dimensions: 45x75x14mm
Description of Functions
The transmitter has 4 buttons for the separate operation of
4 different users.
Operating Instructions
a) Standard configuration: T1-T2 12 bit, T3-T4 18 bit.
b) Configuration with T1-T4 18 bit.
c) Channel division: 1 common + 3 private.
d) Channel division: 2 common + 2 private.
a) Standard configuration T1-T2 12 bit, T3-T4 18 bit.
The transmitter is setup at the factory with the following
configuration: SW2 dip 1 and 2 off, Jumper J1 open and
buttons T1-T2 12 bit, T3-T4 18 bit.
b) Configuration with T1-T4 18 bit.
To set-up the transmitter with all buttons generating 18 bit
code, connect the two poles of the J1 jumper.
c) Channel division; 1 common + 3 private.
To set-up the transmitter to generate 1 common code (e.g.
for a condominium T1) and 3 private users (T2-T3), set
SW2 dip 1 to ON and dip 2 to OFF. As the channel division
is type 4+6 the first 4 dip of SW1 are for programming the
common code and the remaining 6 dip are for programming
the private code.
The set up of buttons T1 to T2 for 12 of 18 bit transmission
is controlled by Jumper J1, see points a) and b) above.
d) Channel division; 2 common + 2 private.
To set-up the transmitter to generate 2 common codes (e.g.
for a condominium T1-T2) and 2 private users (T3-T4), set
SW2 dip 1 and 2 to ON. As the channel division is type 4+6
the first 4 dip of SW1 are for programming the common
code and the remaining 6 dip are for programming the
private code
The set up of buttons T1 to T2 for 12 of 18 bit transmission
is controlled by Jumper J1, see points a) and b) above.
WARNING
− The alkaline 12VDC (23A) battery must be changed
every year in order to guarantee the correct functioning of
the transmitter.
− In order to substitute the dead battery remove the
plastic cover by sliding it off, take the old battery out and
insert the new one taking care to ensure that the polarity
corresponds to that indicated on the container.
− The used battery must be disposed of correctly in the
apt recycling bins.
SEAV s.r.l. declares that the product
Radio commander TXS 4
Complies with the specifications of Directive
R&TTE 99/5/EC.
2 Rev. 1.1 03/07
GB
Loading...