Schneider Electric AP9335TH Installation Instructions

Temperature/Humidity Sensor
(AP9335TH) Installation Instructions

Inventory

4-m (13.12-ft) temperature/humidity

sensor (1)

203-mm (8-in) tie wrap (5)

19-mm x 19-mm (3/4-in x 3/4-in) adhesive

cable tie holder (2)

Installation

Note: If you use a tie wrap to secure the sensor, tighten the tie wrap over the recessed

channel on the sensor. If you use the housing clip, make sure the protrusions on the inside
of the clip snap into the slots in the recessed channel.

25.4-mm x 25.4-mm

(1-in x 1-in) temperat ure/

humidity sensor mount (1)

#8 x 3/4-in sheet

metal screw (1)

Wire clip (6)

Housing clip (1)

#8 wall anchor (1)

Note: Use adhesive cable tie holders, tie wraps, and wire clips to secure the sensor cable.

Vertica l ra il

Door

Wall

Note: Drill a 4.76-mm (3/16-in) pilot hole for the wall anchor.

© 2008 American Power Conver sion. All rights reserved. All APC trademarks are property of

American Power Conversion. Other trademarks are property of their respective owners.

990-3506

11/2008

*990-3506*