Rosemount 8714D Specifications

January 2014

Rosemount 8714D

The Rosemount 8714D Magnetic Flowmeter Simulator attaches to an 8712, or 8732
transmitter’s sensor connections to ensure traceability to NIST standards and long-term
accuracy of the flowmeter system. The 8714D is not compatible with the 8712H
High-Signal transmitter

Table 13. Rosemount 8714 ordering information

Model Description

8714DQ4 Magnetic Flowmeter Simulator - Reference Calibration Standard

Rosemount 8700 Series

Tagging styles

Name Plate

1 Line - 30 Characters

Wire-on

5 Lines - 30 Characters per line

Ordering procedure

To order, select the desired sensor and/or transmitter by
specifying model codes from the ordering table.

For remote transmitter applications, note the cable specification
requirements.

Sensors and transmitters must be selected from Product Data
Sheet 00813-0100-4727.

Standard configuration

Unless the Configuration Data Sheet is completed, the
transmitter will be shipped as follows:

Engineering Units: ft/sec
4 mA (1 V DC): 0
20 mA (5 V DC): 30
Sensor Size: 3-in.
Empty Pipe: On
Sensor Calibration Number: 1000005010000000

Cable requirements for remote transmitters

Description Length P/N

Electrode Cable (20 AWG)

Belden 8762, Alpha 2411 equivalent

Coil Drive Cable (14 AWG)

Belden 8720, Alpha 2442 equivalent

Combination Cable

Electrode Cable (20AWG) and Coil

Drive Cable (18 AWG)

(1) Combination signal and coil drive cable is not recommended for

high-signal magmeter system.

(1)

ft
m

ft
m

ft
m

08712-0061-0001
08712-0061-2003

08712-0060-0001
08712-0060-2003

08732-0753-1003
08732-0753-2004

Remote transmitter installations require equal lengths of
electrode and coil drive cables. Integrally mounted transmitters
are factory wired and do not require interconnecting cables.

Individual cable lengths from 5 to 1000 ft. (1.5 to 300 m) may be
specified. Cable longer than 100 ft. (30 m) is not recommended
for high-signal systems. Combination signal and coil drive cable
should be limited to less than 330 ft (100 m). All cables will be
shipped with the sensor.

Custom configuration (Option Code C1)

If Option Code C1 is ordered, the Configuration Data Sheet
(CDS) must be submitted at the time of order.

Integrally Mounted Rosemount 8732 Transmitters are factory
configured with the attached sensor size and appropriate
calibration number.

www.rosemount.com

25