Pitney Bowes DL100, DL200 Operator's Manual

DL100™, DL200™ Letter Opener

Operator Guide
International English Edition

← Back to Main

NOTICE

The use of this information by the recipient or others for purposes other than the repair, adjustment or operation of Pitney Bowes equipment may constitute
an infringement of patent and/or other intellectual property rights of Pitney Bowes or others. Pitney Bowes assumes no responsibility for any such use of the
information.

Except as provided in writing, duly signed by an ofcer of Pitney Bowes, no license, either express or implied, under any Pitney Bowes or any third party’s

patent, copyright, or other intellectual property rights is granted by providing this information.

SV62219 Rev. D
Fourth Edition, September, 2009.
©2009 Pitney Bowes Inc. All rights reserved.
This book may not be reproduced in whole or in part in any fashion or stored in a retrieval system of any type or transmitted by any means, electronically or
mechanically, without the express written permission of Pitney Bowes. We have made every reasonable effort to assure the accuracy and usefulness of this
manual, however we can not assume responsibility for errors or omissions or liability for the misuse or misapplication of our products.
DL100, DL200 and Pitney Bowes Supply Line are trademarks or registered trademarks of Pitney Bowes, Inc.

Approvals Electromagnetic Compatibility

United States
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are

designed to provide reasonable protection against interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician
CAUTION: Changes or modications to this equipment not expressly approved by the party responsible for compliance (Pitney Bowes) could void the user’s

authority to operate the equipment.

Canada

This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

European Union (CE)

It is certified that this product complies with all applicable Directives of the European Union.

Use only the AC mains cable supplied with the product. For a formal Declaration of Conformity please contact Pitney Bowes Compliance Engineering

Department, Pitney Bowes Limited, Elizabeth Way, Harlow, Essex CM19 5BD England. Telephone [phone]

Compliance and Copyright

← Back to Main

Follow the normal safety precautions for all office equipment:

• Use only Pitney Bowes approved supplies, in particular aerosol dusters. Improper storage and use of aerosol dusters or flammable aerosol dusters, can

cause an explosive-like condition that could result in a personal injury and/or property damage. Never use aerosol dusters labeled flammable and always
read instructions and safety precautions on the duster container label.

• Material Safety Data Sheets can be obtained on the web or from our Supply Line™. Refer to the Contact Information List for more information.

• Use the AC adaptor power supply power cord supplied with the machine and plug it into a properly grounded wall outlet located near the machine and easily

accessible.

• Avoid touching moving parts or materials while the machine is in use. Keep hands, loose clothing, jewelry and long hair away from all moving parts.

• Do not remove covers or defeat safety interlock switches. Covers enclose hazardous parts that should only be accessed by properly trained service

personnel. Immediately report to service any damaged or non-functioning components that renders the unit unsafe.

• Place the unit in an accessible location to allow for proper venting of the equipment and to facilitate servicing.

• Use the AC adaptor power supply included with this letter opener. Third-party adaptors may damage the letter opener.

• Plug the AC adaptor power supply power cord into a properly grounded wall outlet located near the machine and easily accessible.

• The AC adaptor/power cord is the primary means to disconnect the machine from the AC supply.

• Do not route the AC adaptor power supply cords over sharp edges or trapped between furniture.

• Be certain the area in front of the wall outlet into which the AC adaptor power supply is connected is free from obstruction.

• Before clearing a jam, be sure machine mechanisms come to a stop.

• When removing jammed material, avoid using too much force to protect against minor personal injury and damaging equipment.

• To prevent overheating, do not cover the vent openings.

• Avoid using wall outlets that are controlled by wall switches, or shared with other equipment. If a wall outlet controlled by a wall switch is used, mail could be

interrupted if the letter opener is plugged in when the wall switch is used to turn power off.

• Operation of this equipment without periodic maintenance will inhibit optimum operating performance and could cause the equipment to malfunction.

Contact your machine supplier for required service schedule.

• Read all instructions before attempting to operate the equipment.

• Use this equipment only for its intended purpose.

• Always follow the specific occupational safety and health standards for your workplace.

• In the event of use in Norway, the DL100/200 has been tested for IT power supply architecturers up to 230V.

Safety Notes

Moving mechanism can result in

personal injury. Keep hands, long hair,

ties, jewelry and loose clothing away
from moving parts.

Cutter Blade Warning Label

Moving mechanism can result in

personal injury. Keep hands away from

moving parts.

Pinch Point Warning Label

Moving mechanism can result in

personal injury. Keep hands away from

moving parts.

Warning Labels

← Back to Main

Setting Up the DL100 or DL200 Letter Opener

IMPORTANT: Please review the Safety Notes before setting up the DL100 or DL200.

2

3

1