Installation and Assembly:
Ceiling Mount for Panasonic TH-85PF12U and TH-85VX200U
Model: PANA-85CEIL
AEC006009, and AEC012018 Models.
1 of 4
Maximum Load Capacity:
300 lb (136 kg)PANA-85CEIL is not compatible with
ISSUED: 12-18-09 SHEET #: 125-9092-4 03-24-11
A
Parts List
Description Qty. Part #
tilt bracket 2 100-1026
cross support tube 1 100-1023
B
end cap 2 590-1333
C
fiber washer 1 540-9432
D
retaining collar 1 1800-375
E
M8 x 16 mm phillips screw 4 520-9257
F
M5 x 8 mm phillips screw 3 570-0005
G
M16 x 30 mm socket screw 2 520-1346
H
M16 split washer 2 540-2058
I
washer 2 540-2061
J
M6 x 6 mm set screw 2 510-9150
K
5/16 split washer 4 540-9405
L
5/16 flat washer 4 540-9406
M
A
B
H
C D
I JK
Secure ADJ tube (sold separately) to cross support (B) using retaining collar (E), ber washer (D), and one
1
M5 x 8 mm phillips screw (G).
Restrict swivel using two M6 x 6 mm set screws (K).
NOTE: Make sure that M5 x 8 mm phillips screw is positioned inside of notch of ADJ tube as shown in detail 1.
L M
E F G
ADJ Tube
K
G
D
B
E
Detail 1
2 of 4
ISSUED: 12-18-09 SHEET #: 125-9092-4 03-24-11
Notch of ADJ Tube
Secure tilt brackets (A) to cross support tube (B) using four M8 x 16 mm phillips screws (F), 5/16 split washers (L),
2
and 5/16 at washers (M) in desired tilt position as shown in g. 2.1 and 2.2.
Once tilt is established secure two end caps (C) to cross support tube (B).
C
A
B
Fig. 2.1
5°
10° 15°
20°
A
F
L
M
A
Fig. 2.2
Secure two M5 x 8 mm phillips screws (G) to ends of cross support tube (B) as shown below.
3
B
G
3 of 4
ISSUED: 12-18-09 SHEET #: 125-9092-4 03-24-11
Hook display standoffs into keyhole slots onto tilt brackets (A).
4
NOTE: Make sure that standoffs fall to the bottom of keyhole as shown in detail 2.
Secure display to tilt bracket (A) using two M16 x 30 mm socket screws (H), M16 split washers (I), and
washers (J) as shown in detail 3.
A
A
Detail 2
Keyhole
Display Standoff
H
I J
Detail 3
4 of 4
ISSUED: 12-18-09 SHEET #: 125-9092-4 03-24-11
Loading...