peerless-AV IBA3 Installation And Assembly Manual

Installation and Assembly:
Recessed Cable Management and Power Storage Accessory Box
Models: IBA3, IBA3-W
2300 White Oak Circle • Aurora, Il 60502 • (800) 865-2112 • Fax: (800) 359-6500 • www.peerlessmounts.com
ISSUED: 12-27-10 SHEET #: 120-9100-2 06-13-11
Note: Read entire instruction sheet before you start installation and assembly.
WARNING
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an "edge to edge" stud fi nder is highly recommended.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
WALL CONSTRUCTION HARDWARE REQUIRED
Wood Stud Included
Metal Stud Do not attach except with Peerless accessory kit ACC415;
Contact Customer Service for Peerless accessory kit ACC415
Brick Contact Qualifi ed Professional
Drywall Do not attach except with Peerless accessory kit ACC415;
Contact Customer Service for Peerless accessory kit ACC415
Other or unsure? Contact Qualifi ed Professional
Tools Needed for Assembly
• stud fi nder ("edge to edge" stud fi nder is recommended)
• phillips screwdriver
• drill
• 3/16" (5mm) drill bit for wood studs
• level
Table of Contents
Parts List.................................................................................................................................................................................3
Installation to Wood Wall ........................................................................................................................................................4
Cable Management ................................................................................................................................................................ 5
2 of 6
ISSUED: 12-27-10 SHEET #: 120-9100-2 06-13-11
For customer care call 1-800-865-2112
Before you begin, make sure all parts shown are included with your product.
W
A
Parts List
Description Qty. Part # Part #
in-wall box 1 120-P1186 120-2186
B 1-1/2" wood screw 4 500-1090 500-4090 C 4mm security driver 1 560-1133 560-1133 D cable bushing 1 590-1295 590-2295 E cable management clips 2 590-1166 590-1166 F plastic finishing cap 1 590-1123 590-2123 G cable tie 2 590-1168 590-1168 H access plate 1 120-P1187 120-2187
M5 x 6mm phillips screw 5 520-1023 520-2214
I
Parts may appear slightly different than illustrated.
IBA3 IBA3-
A
D
C
E
B
I
G
F
H
3 of 6
ISSUED: 12-27-10 SHEET #: 120-9100-2 06-13-11
For customer care call 1-800-865-2112
Installation to Wood Stud Wall
WARNING
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
• Tighten wood screws so that in-wall box is fi rmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud fi nder is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers are responsible to provide hardware for other types of mounting situations.
In-wall box (A) can be installed between two
1
studs 16" off center. Use a stud fi nder to locate the edges of the stud. Use of an edge-to-edge stud fi nder is highly recommended. Based on its edges, draw two vertical lines down the inside edges of two stud’s. Mark desired center of in-wall box. Draw a horizontal line 2-5/16" (59mm) above desired center of in-wall box. Draw a second horizontal line 4-7/16" (114mm) below fi rst line to outline wall opening between inside edges of studs. Remove drywall inside cut outline.
Insert in-wall box (A) into wall until fl ange is fl ush with drywall as shown in fi g. 1.1.
Level in-wall box, and mark center of the four mounting holes. Make sure that the mounting holes are on stud centerlines. Drill four 3/16" (5mm) dia. holes 1-1/2" (38mm) deep. Make sure in-wall box is level, and secure it using four wood screws (B) as shown in fi g. 1.2.
STUDS
13-1/8"
(333mm)
CENTER OF
IN-WALL BOX
2-5/16"
(59mm)
TOP LINE
OF CUT
OUTLINE
4-7/16"
(114mm)
A
FLANGE
fi g. 1.1
4 of 6
B
fi g. 1.2
ISSUED: 12-27-10 SHEET #: 120-9100-2 06-13-11
For customer care call 1-800-865-2112
Cable Management
Attach access plate (H) to in-wall box (A) with fi ve M5 x 6mm phillips screws (I) as shown in fi gure 2.1. Access
2
plate knockout may be removed for optional installation of electrical gang box.
Insert up to two cable management clips (E) into the desired positions in the in-wall box as shown in fi gure 2.2 for routing cables.
Insert cable bushing (D) into in-wall box for routing cables through in-wall box. Plastic fi nishing cap (F) may also be used if cable management is unnecessary.
Use cable ties (G) to secure cables to cable management clips as shown in fi gure 2.3.
ACCESS PLATE
KNOCKOUT
I
fi g. 2.2
H
fi g. 2.1
fi g. 2.3
E
CABLES
G
D,F
5 of 6
All other brand and product names are trademarks or registered trademarks of their respective owners.
ISSUED: 12-27-10 SHEET #: 120-9100-2 06-13-11
For customer care call 1-800-865-2112
© 2011, Peerless Industries, Inc. All rights reserved.
LIMITED FIVE-YEAR WARRANTY
Peerless Industries, Inc. (“Peerless”) warrants to original end-users of Peerless® products will be free from defects in material and workmanship, under normal
use, for a period of fi ve years from the date of purchase by the original end-user (but in no case longer than six years after the date of the product’s manufacture).
In no event shall the duration of any implied warranty of merchantability or fi tness for a particular purpose be longer than the period of the applicable
express warranty set forth above. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
This warranty does not cover damage caused by (a) service or repairs by the customer or a person who is not authorized for such service or repairs by Peerless,
(b) the failure to utilize proper packing when returning the product, (c) incorrect installation or the failure to follow Peerless’ instructions or warnings when installing,
In no event shall Peerless be liable for incidental or consequential damages or damages arising from the theft of any product, whether or not secured
by a security device which may be included with the Peerless® product. Some states do not allow the exclusion or limitation of incidental or consequential
This warranty is in lieu of all other warranties, expressed or implied, and is the sole remedy with respect to product defects. No dealer, distributor, installer or other
person is authorized to modify or extend this Limited Warranty or impose any obligation on Peerless in connection with the sale of any Peerless® product.
At its option, Peerless will repair or replace, or refund the purchase price of, any product which fails to conform with this warranty.
using or storing the product, or (d) misuse or accident, in transit or otherwise, including in cases of third party actions and force majeure.
damages, so the above limitation or exclusion may not apply to you.
This warranty gives specifi c legal rights, and you may also have other rights which vary from state to state.
www.peerlessmounts.com
© 2011 Peerless Industries, Inc.
6 of 6
ISSUED: 12-27-10 SHEET #: 120-9100-2 06-13-11
For customer care call 1-800-865-2112
Loading...