Page 1
PHM-5 INSTRUCTION MANUAL
Installation
Instruction
Hanging Mount Bracket
PHM-5
Manufactured by:
for
Before attempting to connect or operate this product,
please read these instructions completely.
1
Page 2
PHM-5 INSTRUCTION MANUAL
!
WARNING
This service information is designed for experienced repair technicians and is not designed fro use by
the general public.
It does not contain warnings or cautions to advise nontechnical individuals of potential dangers in
attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional
technicians. Any attempt to service or repair this product or products dealt with in this service
information by anyone else could result in serious injury or death.
CAUTION
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USER
SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
!
!
This symbol warns the user that uninsulated voltage within
the unit may have sufficient magnitude to cause electric
shock. Therefore, it is dangerous to make any kind of
contact with any inside part of this unit.
This symbol warns the user that important literature
concerning the operation and maintenance of this unit has
been included. Therefore, it should be read carefully in
order to avoid any problems.
IMPORTANT SAFETY NOTICE
There are special components used in this equipment which are important for safety. These parts are
indicated by the mark on the schematic and the replacement parts list. It is essential that these
!
critical parts should be replaced with manufacturer’s specified parts to prevent shock, fire, or other
hazards.
Do not modify the original design without permission of manufacturer.
CAUTION
This must be properly and securely mounted to a supporting structure capable of sustaining the weight of the bracket and
camera assembly. Accordingly,
1. The installation should be made by a qualified installer.
2. The installation should be in compliance with local codes.
3. Care should be exercised to select suitable hardware to install the unit, taking into account both the composition of
the mounting surface and the weight the hardware willbe required to sustain.
Be sure to periodically examine the unit and the supporting structure to make sure that the integrity of the installation is intact.
Failure to comply with the foregoing could result in the unit coming loose from the support structure and falling, with resultant
damages or injury to anyone or anything struck by the falling unit.
2
Page 3
PHM-5 INSTRUCTION MANUAL
PRECAUTIONS ON INSTALLATION
The PHM-5 is designed for indoor use, for supporting
the Unitized Camera WV-CS604 and WV-CS404.
(Pipe -Not Supplied)
INSTALLATION
1. Mount ceiling coupling in desired location. Connect
1" NPT pipe (not supplied) to it. Feed video cables
and power lines through pipe.
2. Attach camera mount bracket for the Unitized
Camera to the hanging mount bracket, using (4) #8 x
3/8" bolts provided in the packet (A).
3. Attach the safety wire to the camera bracket. Con
nect the Unitized Camera to the hanging mount
bracket. Finally attach the safety screw to the
camera mount bracket, using the standard screw
(B).
Camera
Mount Bracket
3
Page 4
PHM-5 INSTRUCTION MANUAL
CONNECTION
Assemble the power cable with the connector
provided with the WV-CS604 or WV-CS404 Unitized
Cameras. See operating instruction for the WVCS604 or CS404.
Front view of the male connector in the camera
cable. Pin 1 is in the lower right hand corner.
Connector Information Pin
1. AC24V AC Live
2. AC24V AC Neutral
3. Ground
4. Not Used
CAUTION: For lightning protection of the camera,
pin 3 of the connector must be connected to real
electrical ground.
OUTLINE DRAWING
2.25 R.
4
3
1
2
CL
(4) PEM S-832-2
PIPE COUPLING 1.00" NPT
1.000"
SPECIFICATION:
Dimensions: (See Drawing)
Shipping Weight: 1.0 lbs
STANDARD ACCESSORIES
Ceiling Coupling -1" NPS............. 1 Piece
#8 x 3/8" Bolts (A & C) ................. 4 Pieces
Hanging Mount Bracket ............... 1 Piece
OPEN
1.811"
2.500"
3.742"
3.287"
PHM-5
HANGING MOUNT BRACKET
Rev. 3018/1097
4
Loading...