TGA648FX(fx).book Page 3 Tuesday, June 9, 2009 3:35 PM
English
This unit is an additional handset compatible with the following series of
Panasonic Digital Cordless Phone: KX-TG6481
You must register this handset with your base unit before it can be used.
This installation manual describes only the steps needed to register and
begin using the handset. Please read the base unit’s operating instructions
for further details.
Belt clip ......................................... 1Handset cover
*1 Please read the base unit’s operating instructions for replacement battery
information.
*2 The handset cover comes attached to the handset.
Note:
•
Please read the base unit’s operating instructions for additional/replacement
accessories.
•
This equipment is designed for use in Czech and Slovakia.
•
In the event of problems, you should contact your equipment supplier in the first
instance.
•
For use in other countries, please contact your equipment supplier.
Rechargeable batteries
(HHR-55AAAB or N4DHYYY00005)
*2
.............. 2
............................ 1
Setting up
Connection
•
Use only the supplied Panasonic AC adaptor PQLV219CE.
•
The AC adaptor must remain connected at all times. (It is normal for the adaptor
to feel warm during use.)
3
TGA648FX(fx).book Page 4 Tuesday, June 9, 2009 3:35 PM
Battery installation/Battery charge
When the language selection is displayed after installing the batteries for the
first time, you can select your desired language.
{V}/{^}
: Select your desired language. i M i {ic
Important:
•
Use the supplied rechargeable batteries. For replacement, we recommend
using the Panasonic rechargeable batteries noted in the base unit’s operating
instructions.
•
Wipe the battery ends (S, T) with a dry cloth.
•
Avoid touching the battery ends (S, T) or the unit contacts.
•
Confirm correct polarities (S, T).
•
USE ONLY Ni-MH batteries AAA (R03) size.
•
Do NOT use Alkaline/Manganese/Ni-Cd batteries.
Place the handset on the charger for about 7 hours before initial use.
Note:
•
The handset display may show “Please wait for 1 minute.” when the
handset is placed on the charger if it is not registered to the base unit.
•
If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
charge again.
S, T
) and the charge contacts with a dry cloth and
}
Display language
9 display languages are available.
You can select “ ”, “ ”,“ ”, “ ”,
“ ”, “ ”, “ ”, “ ” or “ ”.
If you select a language you cannot read:
M i {V}
i M i {ic}
2 times i M 2 times i
4
{ic} i K i {^}
{V}/{^}
: Select your desired language.
3 times i
TGA648FX(fx).book Page 5 Tuesday, June 9, 2009 3:35 PM
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {ic} for
few seconds to turn the handset on.
1
Handset:
Lift the handset and press {ic}.
2
Base unit:
Press and hold
•
If all registered handsets start ringing, press the same button to stop. Then
repeat this step.
3
Handset:
Place the handset on the base unit.
•
Continue the operation even when the handset display shows
“
Please wait for 1 minute.”.
4
With the handset still on the base unit, wait until a confirmation tone sounds
and
w
Note:
•
If an error tone sounds, or if w is still flashing, register the handset according
to the base unit’s operating instructions.
For your safety
To prevent severe injury and loss of life/property, read this section carefully before using the
product to ensure proper and safe operation of your product.
WARNIN G
Power connection
•
Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may
cause electric shock and/or excessive heat resulting in a fire.
•
Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the
power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation
defect from moisture, etc. resulting in a fire.
•
Unplug the product from power outlets if it emits smoke, an abnormal smell, or makes an
unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has
stopped emitting and contact an authorised service centre.
Installation
•
To prevent the risk of fire or electrical shock, do not expose the product to rain or any type
of moisture.
•
Do not place or use this product near automatically controlled devices such as automatic
doors and fire alarms. Radio waves emitted from this product may cause such devices to
malfunction resulting in an accident.
Operating safeguards
•
The use of excessive sound volume through earphones, headphones, or headsets may
cause hearing loss.
{x}
stops flashing.
for about 5 seconds, until the registration tone sounds.
5
TGA648FX(fx).book Page 6 Tuesday, June 9, 2009 3:35 PM
CAUTION
Installation and location
•
The AC adaptor is used as the main disconnect device. Ensure that the AC outlet is
installed near the product and is easily accessible.
Battery
•
We recommend using the supplied batteries or additional/replacement batteries noted in
the base unit’s operating instructions for replacement battery information.
rechargeable Ni-MH batteries AAA (R03) size
•
Do not mix old and new batteries.
•
Do not open or mutilate the batteries. Released electrolyte from the batteries is corrosive
and may cause burns or injury to the eyes or skin. The electrolyte is toxic and may be
harmful if swallowed.
•
Exercise care when handling the batteries. Do not allow conductive materials such as
rings, bracelets, or keys to touch the batteries, otherwise a short circuit may cause the
batteries and/or the conductive material to overheat and cause burns.
•
Charge the batteries provided with or identified for use with this product only, in accordance
with the instructions and limitations specified in this manual.
•
Only use a compatible base unit (or charger) to charge the batteries. Do not tamper with
the base unit (or charger). Failure to follow these instructions may cause the batteries to
swell or explode.
.
USE ONLY
Other information
•
Operating the product near electrical appliances may cause interference. Move away from
the electrical appliances.
•
Use only the power cord and batteries indicated in this manual. Do not dispose of batteries
in a fire. They may explode. Check with local codes for possible special disposal
instructions.
Routine care
•
Wipe the outer surface of the product with a soft moist cloth.
•
Do not use benzine, thinner, or any abrasive powder.
Splash resistance (handset only)
The handset is designed to be splash-resistant. You can use the handset with wet hands.
(IP 54 Standard)
•
Do not immerse in water or leave under running water.
•
Keep the handset away from salt water.
•
Avoid exposure to prolonged high humidity.
•
Since water in headset jack may cause damage, close the headset jack cover when the
optional headset is not in use. When the optional headset is connected, do not use the
handset with wet hands.
•
If the handset is wet, wipe with a soft dry cloth.
•
The base unit/charger is not designed to be splash resistant. Do not place the handset on
the base unit/charger if the handset is wet.
Shock resistance (handset only)
The handset is designed to be shock-resistant, however, it should not be thrown or stepped
on.
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.