Panasonic AK-HDC931P User Manual
Installing the board in a Multi-Format Camera
1 Remove the left and right side panels on the Multi-Format Camera (AK-HC931P).
2 Remove the blank panel (right side of camera), then feed the cable (supplied with the
board) through the rectangular opening under the top panel and insert it into the
connector on the opposite side.
5
7
8
DOWN
CONV
Down Converter Board
Model No. AK-HDC931P
Blank panel
Heat sink
Connector
Insert the cable into the connector on the opposite
(left) side of the camera(inside of the heat sink).
Rectangular opening
CAUTION:
These servicing instructions are for use by qualified service personnel only. To
reduce the risk of electric shock do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so.
6
5
6
DOWN
CONV
7
8
3 Insert this board (down converter unit) into slot 6 of the camera’s circuit board.
4 Insert the other end of the cable into the connector on the board itself.
Printed in Japan
VQT0B70
F0902H0-5
@
3
Down converter board
5
6
7
8
DOWN
CONV
Loading...