BELT SANDER
800W
INSTRUCTION MANUAL SPECIFICATIONS
Input: |
230-240V ~ 50Hz |
Power: |
800W |
Belt Speed: |
380m /min |
Belt Surface: |
75 x 142mm |
Belt Size: |
75 x 533mm |
Weight: |
3.4kg |
ozito.com.au
WHAT’S IN THE BOX
Belt Sander
Sanding Belt
BSR-7000
KNOW YOUR PRODUCT |
SETUP & PREPARATION |
||||
BELT SANDER |
|
|
1. DUST BAG |
||
1 |
Front Handle |
5 |
Rear Handle |
||
|
|||||
2 |
Belt Tracking Knob |
6 |
Dust Bag |
|
|
3 |
On/Off Trigger |
7 |
Belt Tensioning Lever |
WARNING: ENSURE THE TOOL IS SWITCHED OFF AND |
|
4 |
Lock on Button |
8 |
Front Roller |
DISCONNECTED FROM THE POWER SUPPLY BEFORE |
|
PERFORMING ANY OF THE FOLLOWING STEPS. |
|||||
|
|
|
|
||
|
|
|
|
Fitting the Dust Bag |
|
|
|
|
|
1 Slide the dust bag |
|
|
|
|
|
onto the dust ejection |
|
|
|
|
|
port until it clicks into |
|
|
|
|
|
place. |
|
1 |
2 |
3 |
4 |
5 |
6 |
|
|
|
|
|
2 Ensure the dust bag is closed |
|
|
|
|
|
before starting operation. |
|
|
Emptying the Dust Bag |
|
|
1 Unzip the dust bag |
|
|
and empty the dust |
7 |
8 |
into a bin. |
|
ACCESSORIES
9 Sanding Belt (fitted)
2 Ensure the dust bag is closed before starting operation.
9
ONLINE MANUAL
Scan this QR Code with your mobile device to take you to the online manual.
2. SANDING BELT
Fitting the Sanding Belt
1 Place the sander on its left side.
2 Release the belt tension by pushing the tensioning lever all the way towards the front.
3 Place the belt over the front and rear rollers. 
CAUTION: THE ARROWS ON THE BELT MUST BE ALIGNED WITH THE MARKINGS ON THE BELT SANDER. INCORRECT FITMENT COULD CAUSE THE BELT TO BREAK. BELTS ARE NOT COVERED BY THE WARRANTY.
4 Once the belt is in the correct position, pull the tensioning lever backwards to secure the belt.
Removing the Sanding Belt
1 Release the belt tension by pushing the tensioning lever all the way towards the front.
2 Remove the belt from the rollers
OPERATION
3. BELT ADJUSTMENT
Tracking Adjustment
CAUTION: ENSURE BODY PARTS, CORDS, WORKPIECES AND ANY LOOSE ITEMS ARE CLEAR OF THE SANDING BELT BEFORE PERFORMING THE FOLLOWING STEPS.
It is necessary to ensure the belt is tracking correctly, in a straight line, to avoid the belt ‘tracking off’ the belt sander’s rollers.
1 Turn the sander upside down and hold it firmly with one hand.
2 Press the on/off trigger to start the sander and observe the tracking of the sanding belt.
3 If the belt tracks outwards, rotate the tracking knob anticlockwise.
If the belt tracks inward, rotate the knob clockwise.
4Adjust the belt until its outer edge is even with the outer edge of the rear roller. Make sure that the belt does not rub against the rear guide strip.
Loading...