This drawing shows
the location(s) of the
warning decal(s). If
a decal is missing
or illegible, see the
front cover of this
manual and request
a free replacement
decal. Apply the
decal in the location
shown. Note: The
decal(s) may not be
shown at actual size.
IFIT and NORDICTRACK are registered trademarks of ICON Health & Fitness, Inc. App Store is a trademark of
Apple Inc., registered in the U.S. and other countries. Android and Google Play are trademarks of Google Inc. The
BLUETOOTH® word mark and logos are registered trademarks of Bluetooth SIG, Inc. and are used under license.
IOS is a trademark or registered trademark of Cisco in the U.S. and other countries and is used under license.
2
IMPORTANT PRECAUTIONS
WARNING: To reduce the risk of serious injury, read all important precautions and
instructions in this manual and all warnings on your elliptical before using your elliptical. ICON
assumes no responsibility for personal injury or property damage sustained by or through the use of
this product.
1. It is the responsibility of the owner to ensure
that all users of the elliptical are adequately
informed of all precautions.
2. Before beginning any exercise program,
consult your physician. This is especially
important for persons over age 35 or persons with pre-existing health problems.
3. The elliptical is not intended for use by
persons with reduced physical, sensory, or
mental capabilities or lack of experience and
knowledge, unless they are given supervision or instruction about use of the elliptical
by someone responsible for their safety.
4. Use the elliptical only as described in this
manual.
5. The elliptical is intended for home use only.
Do not use the elliptical in a commercial,
rental, or institutional setting.
6. Keep the elliptical indoors, away from moisture and dust. Do not put the elliptical in a
garage or covered patio, or near water.
7. Place the elliptical on a level surface, with at
least 4 ft. (1.2 m) of clearance in the front of
the elliptical, 6 ft. (1.8 m) in the rear, and 2 ft.
(0.6 m) on each side. To protect the floor or
carpet from damage, place a mat under the
elliptical.
9. Keep children under age 13 and pets away
from the elliptical at all times.
10. The elliptical should not be used by persons
weighing more than 325 lbs. (147 kg).
11. Wear appropriate clothes while exercising;
do not wear loose clothes that could become
caught on the elliptical. Always wear athletic
shoes for foot protection while exercising.
12. Hold the handlebars or the handrails
when mounting, dismounting, or using the
elliptical.
13. The heart rate monitor is not a medical
device. Various factors may affect the accuracy of heart rate readings. The heart rate
monitor is intended only as an exercise aid
in determining heart rate trends in general.
14. The elliptical does not have a freewheel; the
pedals will continue to move until the flywheel stops. Reduce your pedaling speed in
a controlled way.
15. Keep your back straight while using the elliptical; do not arch your back.
16. Over exercising may result in serious injury
or death. If you feel faint, if you become short
of breath, or if you experience pain while
exercising, stop immediately and cool down.
8. Inspect and properly tighten all parts each
time the elliptical is used. Replace any worn
parts immediately.
3
STANDARD SERVICE PLANS
all
4
BEFORE YOU BEGIN
Thank you for selecting the revolutionary
NORDICTRACK® FREESTRIDE TRAINER FS3I
elliptical. The FREESTRIDE TRAINER FS3I elliptical
provides an impressive selection of features designed
to make your workouts at home more effective and
enjoyable.
For your benefit, read this manual carefully before
you use the elliptical. If you have questions after
Length: 4 ft. 11 in. (150 cm)
Width: 2 ft. 5 in. (74 cm)
Handlebar
Fan
Accessory Tray
reading this manual, please see the front cover of this
manual. To help us assist you, note the product model
number and serial number before contacting us. The
model number and the location of the serial number
decal are shown on the front cover of this manual.
Before reading further, please familiarize yourself with
the parts that are labeled in the drawing below.
Tablet Holder
Console
Pedal
Wheel
Handle
Leveling Foot
5
PART IDENTIFICATION CHART
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. Extra parts may be included.
M4 x 16mm
Screw (98)–4
M6 x 20mm
Patch Screw
(42)–6
M4 x 16mm
Machine Screw
M8 x 14mm
Screw (82)–2
M10 x 45mm
Screw (78)–4
(114)–4
Shoulder
M4 x 20mm
Screw (136)–6
M10 x 20mm
Patch Screw (95)–3
M8 Washer
(89)–2
M4 x 30mm Screw
(135)–10
M10 x 20mm
Hex Screw (96)–8
M10 Small
Washer (132)–4
6
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you nish all assembly steps.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 6.
1. Go to www.nordictrackservice.com/
registration on your computer and register
your product.
• activates your warranty
• saves you time if you ever need to contact
Customer Care
• allows us to notify you of upgrades and offers
• In addition to the included tool(s), assembly
requires the following tools:
one Phillips screwdriver
two adjustable wrenches
one rubber mallet
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
Note: If you do not have Internet access, call
Customer Care (see the front cover of this
manual) and register your product.
7
2. Orient the Frame (1) and the Upright (2) as
shown.
Tip: Avoid pinching the wires. With the help
of another person, attach the Upright (2) to the
Frame (1) with eight M10 x 20mm Hex Screws
(96); start all the Hex Screws, and then
tighten them.
2
2
3. Connect the small Main Wire (45) in the left side
of the Upright (2) to the Reed Switch Wire (56) in
the left side of the Frame (1).
Then, connect the large Main Wire (45) in the
right side of the Upright (2) to the Frame Wire
(A) in the right side of the Frame (1).
96
96
1
3
45
56
Avoid
pinching
the wires
2
1
96
96
1
45
A
2
1
8
4. Slide the right Front and Rear Shield Caps
(23, 24) downward and press them onto the
Right Inner and Outer Shields (21, 22).
4
Repeat this step on the left side of the
elliptical.
5. See the lower drawing. Identify the Right Pedal
Arm (94) and orient it as shown.
See the upper drawing. Using a plastic bag
to keep your fingers clean, apply a generous
amount of the included grease to the axle on the
Right Pedal Arm (94). Then, insert the axle into
the Right Leg (5) from the direction shown.
Attach the Right Pedal Arm (94) with an
M8 x 14mm Shoulder Screw (82), a Leg Cap
(93), and an M8 Washer (89).
Attach the Left Pedal Arm (not shown) to the
Left Leg (6) in the same way.
24
23
21
5
6
94
Grease
22
5
89
93
82
94
9
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.